500 / 600W pure sine wave grid tie inverter for 10.8-30/22-60V DC/AC wind turbines
500W 600W Wind grid tie inverter for single phase DC(WDL) or 3 phase AC(WAL) output wind turbine
10.8-30V/22-60V with dump load resisitor
LCD on inverter is optional
INTRODUCTION
The grid-tie inverter can transfer wind energy from wind generators directly into the home grid using no
extra equipment. It can be
connected to any outlet (conventional network) in the home. The grid-tie
inverter
controls the phase and the frequency and voltage of the power generated by the wind generator. It produces
a pure sine-wave and matches that of the grid.
This model grid-tie has build in
bridge rectifier and dump load controller, it can maintain the rotating
speed of
the wind turbine and keep the voltage from the wind turbine
always at the range of the rated range of the grid
tie inverter. It also
has a high voltage protection function, when the wind is too big, and
the dump load controlling
system can’t keep the output voltage from the wind turbine, the controller will disconnect itself from the wind turbine,
so it is very safe to be used.
There are 5 terminals on the left side of the inverter, 3 red terminals will be connected to the three phase output
from the wind turbine, and 2 black
terminals will be connected to dump load resistors.
There are 4 LED indicators, 3 green indicators and 1 red indicator, 3 green LED indicators will start to cycle from left to
right when the grid and AC input supply is detected. This indicates the inverter is operating under normal condition. The
rate of the cycling is according to how much power is being output from the wind turbine. The bigger the output power is,
the faster the rate is. If there is no AC grid detected, the red LED will be on, the inverter will not put out power, this is called
“Island Protection” .
LCD display Function: (only available for thoese Models "-LCD")
On
the LCD Panel of the inverter, there is one AC output socket, that will
connect the AC output cable to home grid. The
LCD display will display the grid AC voltage, current , active power and electric energy that combined to the energy .
1. Electric parameters measurement function (voltage, current and active power, electric energy).
2. Running time function (record load cumulative working hours).
3. Backlight function.
4. Power down data save function (save the number of kWh, operation time).
5. Large screen LCD display (display voltage, current, power, active power, cumulative running time)
Key Function:
UP: Short press will display power, electricity, current and voltage in anti-sequence.
DOWN: Short press will display power, electricity, current and voltage in sequence.
BACK LIGHT: Short press will open or close backlight.
Electrical Specifications:
WAL----------AC INPUT
WDL--------DC INPUT
Model | SUN-500G_WDL | |
Normal AC Output Power | 450W | |
Maximum AC Output Power | 500W | |
AC Output Voltage Range | 110V/120V 230V/240V | 90V ~ 130V 190V~260V |
AC Output Frequency Range | 46Hz ~ 65Hz | |
Total Harmonic Distortion(THD) | <5% | |
Power Factor | 0.99 | |
DC Input Voltage Range (the test point is at the output of the rectifier) | 10.8v~30v / 22V~60V | |
Peak Inverter Efficiency | 92% | |
Standby Power consumption | <1.5W | |
Output Current Waveform | Pure Sine-wave | |
MPPT Function | Yes | |
Over Current Protection | Yes | |
Over Temperature Protection | Yes | |
Reverse Polarity Protection | Yes | |
Island Protection | Yes | |
Stackable | Yes |
Model | SUN-500G_WDL-LCD | |
Normal AC Output Power | 450W | |
Maximum AC Output Power | 500W | |
AC Output Voltage Range | 110V/120V | 90V ~ 130V |
AC Output Frequency Range | 46Hz ~ 65Hz | |
Total Harmonic Distortion(THD) | <5% | |
Power Factor | 0.99 | |
DC Input Voltage Range (the test point is at the output of the rectifier) | 22V~60V/10.8-30V (the test point is at the output of the rectifier) | |
Peak Inverter Efficiency | 92% | |
Standby Power consumption | <1.5W | |
Output Current Waveform | Pure Sine-wave | |
MPPT Function | Yes | |
Over Current Protection | Yes | |
Over Temperature Protection | Yes | |
Reverse Polarity Protection | Yes | |
Island Protection | Yes | |
Stackable | Yes |
|
Model | SUN-500G_WAL | |
Normal AC Output Power | 450W | |
Maximum AC Output Power | 500W | |
AC Output Voltage Range | 110V/120V | 90V ~ 130V |
AC Output Frequency Range | 46Hz ~ 65Hz | |
Total Harmonic Distortion(THD) | <5% | |
Power Factor | 0.99 | |
DC Input Voltage Range (the test point is at the output of the rectifier) | 22V~60V | |
Peak Inverter Efficiency | 92% | |
Standby Power consumption | <1.5W | |
Output Current Waveform | Pure Sine-wave | |
MPPT Function | Yes | |
Over Current Protection | Yes | |
Over Temperature Protection | Yes | |
Reverse Polarity Protection | Yes | |
Island Protection | Yes | |
Stackable | Yes |
Model | SUN-500G_WAL-LCD | |
Normal AC Output Power | 500W | |
Maximum AC Output Power | 450W | |
AC Output Voltage Range | 220V/230V/240V | 190V ~ 260V |
110V/120V | 90V ~ 130V | |
AC Output Frequency Range | 46Hz ~ 65Hz | |
Total Harmonic Distortion(THD) | <5% | |
Power Factor | 0.99 | |
DC Input Voltage Range | 10.8V ~ 30V 22V~60V | |
Peak Inverter Efficiency | 92% | |
Standby Power consumption | <1.5W | |
Output Current Waveform | Pure Sine-wave | |
MPPT Function | Yes | |
Over Current Protection | Yes | |
Over Temperature Protection | Yes | |
Reverse Polarity Protection | Yes | |
Island Protection | Yes | |
Stackable | Yes |
Model | SUN-600G_WDL | |
Normal AC Output Power | 540W | |
Maximum AC Output Power | 600W | |
AC Output Voltage Range | 110V/230V | 90V~130V 190V ~ 260V |
AC Output Frequency Range | 46Hz ~ 65Hz | |
Total Harmonic Distortion(THD) | <5% | |
Power Factor | 0.99 | |
DC Input Voltage Range (the test point is at the output of the rectifier) | 22V~60V (the test point is at the output of the rectifier) | |
Peak Inverter Efficiency | 92% | |
Standby Power consumption | <1.5W | |
Output Current Waveform | Pure Sine-wave | |
MPPT Function | Yes | |
Over Current Protection | Yes | |
Over Temperature Protection | Yes | |
Reverse Polarity Protection | Yes | |
Island Protection | Yes | |
Stackable | Yes |
Model | SUN-600G_WDL-LCD | |
Normal AC Output Power | 540W | |
Maximum AC Output Power | 600W | |
AC Output Voltage Range | 110V/230V | 90V~130V 190V ~ 260V |
AC Output Frequency Range | 46Hz ~ 65Hz | |
Total Harmonic Distortion(THD) | <5% | |
Power Factor | 0.99 | |
DC Input Voltage Range (the test point is at the output of the rectifier) | 22V~60V (the test point is at the output of the rectifier) | |
Peak Inverter Efficiency | 92% | |
Standby Power consumption | <1.5W | |
Output Current Waveform | Pure Sine-wave | |
MPPT Function | Yes | |
Over Current Protection | Yes | |
Over Temperature Protection | Yes | |
Reverse Polarity Protection | Yes | |
Island Protection | Yes | |
Stackable | Yes |
Model | SUN-600G_WAL | |
Normal AC Output Power | 540W | |
Maximum AC Output Power | 600W | |
AC Output Voltage Range | 110V/120V | 90V ~ 130V |
AC Output Frequency Range | 46Hz ~ 65Hz | |
Total Harmonic Distortion(THD) | <5% | |
Power Factor | 0.99 | |
DC Input Voltage Range (the test point is at the output of the rectifier) | 10.8V-30V / 22V~60V | |
Peak Inverter Efficiency | 92% | |
Standby Power consumption | <1.5W | |
Output Current Waveform | Pure Sine-wave | |
MPPT Function | Yes | |
Over Current Protection | Yes | |
Over Temperature Protection | Yes | |
Reverse Polarity Protection | Yes | |
Island Protection | Yes | |
Stackable | Yes |
Model | SUN-600G-WAL-LCD | |
Normal AC Output Power | 540W | |
Maximum AC Output Power | 600W | |
AC Output Voltage Range | 220V/230V 110V/120V | 190V ~ 260V 90V~130V |
AC Output Frequency Range | 46Hz ~ 65Hz | |
Total Harmonic Distortion(THD) | <5% | |
Power Factor | 0.99 | |
DC Input Voltage Range (the test point is at the output of the rectifier) | 22V~60V | |
Peak Inverter Efficiency | 92% | |
Standby Power consumption | <1.5W | |
Output Current Waveform | Pure Sine-wave | |
MPPT Function | Yes | |
Over Current Protection | Yes | |
Over Temperature Protection | Yes | |
Reverse Polarity Protection | Yes | |
Island Protection | Yes | |
Stackable | Yes |
Delivery will not be make even if the order placed by those buyers.We believe that all problems could be fixed by communication
between buyers and sellers as long as both of us are honest and understanding.