leaf mould brass flower making tool

+socket plug adapters for US, UK, AU buyers 

1.Leaf mould made of brass,5sm or 2.08" length, 3sm or 1.25" width 

2. soldering iron: 40w/110v with wooden handle for North American buyers or the same one of 40w/220v for European, Australian and other buyers.

The fabric must be processed with a solution of polyvinyl alcohol (PVA) or a 

gelatine solution. 

With the help of this press-form you can make leaves of the maximum size 

(5.5cm x 3.5cm), as well as any smaller size. 

Place the top part into the soldering iron and plug it in. Wait for 4 minutes for 

it to get really hot. All this time, the top part must coincide with the bottom 

matrix.

The processed textile must be slightly dampened with the pulveriser and 

placed face down onto the bottom matrix. Coincide the top part with the 

bottom again and press down. Wait for 7-10 seconds. Take the textile with 

the imprint out and cut the leaves of the needed size.


How to use the soldering iron:

you just insert the tool into heating source of soldering iron and put it out after work is finished. 
You can change the instruments in the hot soldering iron, it is not necessary to stop work over a flower, you just turn off the soldering iron, pull out the tool by the plier, insert the next one and then plug soldering iron in. Usually it takes only a couple of minutes to the next instrument was ready to work with. Keep in mind that the small tools are heated much faster than large ones. 

Shipping:

I ship by registered mail with tracking number.I combine shipping.

Payment:

via PayPal

Please check my other sets, moulds and materials for fabric flowers.