Edwards Swager not included

1 Jenny Roll set for the Edwards Swagers with a 3/4 inch 19mm shank and the 3/16th pins that locate and drive, upper roll has a 5/8 whitworth thread, but you will need to make a spacer/washer to keep the upper roll away from the pin, if you need a different thread or non at all please ask.

 The Jenny roll is used for forming a flange on the the edge of work that can then be used as a flange in a wheel arch for example or made into a wired edge in sheet Steel or Aluminium, rolls are on a 19mm 3/4 inch I/D and are designed for 2 inch shaft centres. To check fitment with your machine align shafts parallel and measure centres, they should be 2 inches.

Swager not included. Please note this is just the rolls themselves all other photos are for ref only. If you would like a set without the pin drive send me an email, I have these also. Please contact for a more precise postage rate for overseas.