Choose this universal remote control duplicator for automatic garage doors, gates, windows, lights, etc. Configuration has never been easier. All you need to do is place the 2 remote controls next to each and press both buttons simultaneously for the duration of the synchronization. Once the green button lights up, your remote control is ready to use. The AZ Remote® Universal Remote Control can copy up to 4 different codes and will allow you to duplicate your old remote controls in just a few seconds. Compatible with over 90% of remote controls that operate with a frequency of 433.92 MHz. Features: Power Supply: 1 Battery. Signal range: 100 m (with no obstructions). Signal Frequency: 433.92 MHz. Contents: Battery and instruction manual in French. Exhaustive list of compatible remote controls available.
PLEASE NOTE: Not compatible with rolling code remote controls.
1. Reset. To reset, press the buttons 1 and 2 of the duplicator remote control at the same time for approximately 10 seconds. You will see the blue light flash quickly for about 2 seconds, then flash more slowly, this means that the remote control has been reset. You can then release the buttons. When you press one of the two buttons after this step, the blue stops flashing.
2. Copy the code. Place the remote control duplicator and the remote control that you wish to copy next to each other (see figure 1). First of all, press and hold one of the buttons on the duplicator remote control, the blue light appears once then press and hold one of the buttons on the remote control to be copied. If the blue light appears without flashing, the operation was successful. Repeat the same operation to copy the other buttons. If no light appears after 15 seconds, try again.