For Our 2 - Wires Design only-
1. Remove the cable from package. Purple Pin 6 Grey Pin 14
2. Carefully, remove the OBDII connector from the dash by depressing the tabs on the sides.
3. Remove the two grey pin retainers from the back of the connector.
4. One at a time, remove & replace the yellow and brown wires from locations 6 & 14. For a 2018 truck, For the 2019 and 2020 follow the same steps. NOTE: If you install the cable and can?t connect to the truck, try swapping the wires.
Note: A 1.5mm wide flat terminal release tool or a pointed sewing needle works for removing pins.
OBDII Connector
5. Reinstall the two grey pin retainers.
6. Locate the green ?Star? connector above the parking brake. For 2018 plug the harness into any empty space, for 2019 and 2020 plug the harness into the fifth position from the left at the bottom.
2018 Star Connector
2019/2020 Star connector
7. Cover & insulate the pins you removed from the OBDII connector.
8. Reinstall the OBDII connector into the factory location.
The bypass cable will also likely be needed in the following scenarios:
- Changing the tire size with EZ LYNK
- Adding an aftermarket remote start
- Using a Snap-on or other OBDII scanner
- Adding AMP Steps
- Alpha OBD
- Elm Support
- Efi Live Support