The RYCA RR-1 Hardtail Frame Assembly converts your stock Suzuki S40 / Savage into a classic hardtail bobber. It is entirely bolt-on, with no welding or fabrication required, and provides mounting points for the Ryca motors RR-1 solo seat, battery, and fender. Includes rear axle, axle spacer, axle nuts, and mounting hardware.
Installing the hardtail assembly (along with the recommended front fork lowering mod) lowers the stock Suzuki by 2 inches and stretches the wheel base by 3.5 inches.
[Note: chain drive conversion is mandatory when using this hardtail assembly. Also, the stock Suzuki exhaust will not work with the hardtail. See the RR-1 assembly guide on our you tube page.]
Includes:
- RR-1 rear axle
- RR-1 axle spacer
- M16 axle nuts (x2)
- M16 oversized washers (x2)
- M10 x 260mm bolt
- M8 x 25mm header point bolts (x2)
WARNING: Apply medium strength threadlocker on all metal fasteners, nuts, bolts, and screws. Failure to do so could allow them to vibrate loose and cause loss of control of your motorcycle, resulting in personal injury and/or property damage.