1)Blinds width up to 3000mm x 3000mm drop (measurement from bracket to bracket)

2)Tubular motor with built in receiver

3)One 100% Blockout blind fabric - Vibe- any color

4)One Sunscreen blind fabric - Vibe- any color

5)Bottom bar - oval - clear anodised (silver) with side cap

6)One pair of steel bracket, gap 30mm

7)One spring loaded end cap,

8)One drive wheel,

9)One Hand held remote control, single or 16 channels, white or black

10)One battery for remote control,

11)One remote control holder,

12)Heavy duty blind tube 43-63mm / light duty blind tube 43mm

13)One Instruction.

ALL PRICES IN AUSTRALIA DOLLAR AND INCLUDE GST
INSTALLATION & FREIGHT NOT INCLUSIVE IN THE ABOVE PRICE
ALL PRICES SUBJECT TO CHANGE WITHOUT NOTICE
NOTE: WIDTH & DROP NOT IN THE TABLE WILL QUOTED SEPARATELY

INTRODUCTION

In order to measure your window for blind fitting, you will need a tape measure and a pen or pencil to record your measurements.

You must then determine what kind of fitting you would like. The two options are:

"Recess" - This is when you want your blind to fit inside the window recess (frame)

"Face Fit" - This is when you want your blind to hang outside the window recess.

RECESS MEASUREMENT:

Measure the drop in three different places from the top of the recess to the bottom of the window sill as illustrated inredbelow.

Measure the width in three different places from wall to wall as illustrated inbluebelow.

FACE FIT MEASUREMENT:

Measure the exact drop or where you would like the blind to be as illustrated inredbelow.

Measure the exact width or where you would like the blind to be as illustrated inbluebelow.