1)Blinds width up to 3000mm x 3000mm drop (measurement from bracket to bracket)

2)Tubular motor with built in receiver

3)One 100% Blockout blind fabric - Vibe- any color

4)One Sunscreen blind fabric - Vibe- any color

5)Bottom bar - oval - clear anodised (silver) with side cap

6)One pair of steel bracket

7)One spring loaded end cap

8)One drive wheel

9)Two blind tubes

10)One Instruction

TOP ALUMINIUM TUBE (43mm diameter tube for blinds lenght less then 2600mm) (50mm diameter tube for blinds lenght more than 2700mm )

END CAP

BRACKETS (Comes in pairs. One of the brackets is holding the motor; the other bracket is holding the END CAP)

Suitable for face fit & recess fit, easy remove & install. The gap between bracket and motor = 17mm, bracket between end cap =13mm, Total gap =30mm.

*Blinds System components only availabe with the purchase of the motor
*All postage / delivery costs to be paid by the buyer. Do not pay until you have received the invoice. We do not profit from postage
*You are only purchasing the blinds motor and components kit. Purchase a package to make things easier.
*Price special for eBay customers only
*Go to http://www.autoblinds.com.au for support / installation on the products
*Look out for our other products including Electric Curtain System, Electric Roller Blind System, C-Bus Motor, Blinds motor
*PO Box delivery addresses not accepted, please supply alternative address.
*Contact phone must supply for the courier/fright.

ALL PRICES IN AUSTRALIA DOLLAR AND INCLUDE GST
INSTALLATION & FREIGHT NOT INCLUSIVE IN THE ABOVE PRICE
ALL PRICES SUBJECT TO CHANGE WITHOUT NOTICE
NOTE: WIDTH & DROP NOT IN THE TABLE WILL QUOTED SEPARATELY

INTRODUCTION

In order to measure your window for blind fitting, you will need a tape measure and a pen or pencil to record your measurements.

You must then determine what kind of fitting you would like. The two options are:

"Recess" - This is when you want your blind to fit inside the window recess (frame)

"Face Fit" - This is when you want your blind to hang outside the window recess.

RECESS MEASUREMENT:

Measure the drop in three different places from the top of the recess to the bottom of the window sill as illustrated inredbelow.

Measure the width in three different places from wall to wall as illustrated inbluebelow.

FACE FIT MEASUREMENT:

Measure the exact drop or where you would like the blind to be as illustrated inredbelow.

Measure the exact width or where you would like the blind to be as illustrated inbluebelow.