FRANKE FRAGRANIT NEPTUNE
SOAP DISPENSER
LIMITED TIME OFFER- LOWEST PRICE ON EBAY AND EVERYWHERE...
| Diameter | 25 mm |
|---|---|
| Remarks | Requires 1 x 25mm diameter hole |
Installation
Either use an existing hole or prepare one specially. The hole should be 25mm in diameter. It is recommended that the centre of the hole should be no more than 100mm from the inside edge of the basin or sink. When choosing a location remember to consider any obstructions underneath the surface.
Pass the connector through the rubber washer and in turn through the hole. Then do up the nut, finger tight, from beneath. Push the bottle over the four lugs at the bottom of the connector, until it clicks into position. Push the dip into the bottom of the pump.
Fill the bottle (500ml) through the connector and pass the head assembly down into the connector.You can use the diptube asa measure of how full the bottle is.
Operation
The pump is worked by a single, full movement downward on the dispenser head. When first used it will be necessary to prime the pump with several movements. Each movement will dispense 1ml of liquid of 45o to the work place.
Care and Cleaning
It is very important that the product be wiped clean with a soft damp cloth and wiped dry after every use to ensure longevity of the finish. Under no circumstances should an abrasive cleaner or combination cleaner/polish be used on these products. The abrasive nature of such products will eventually destroy the finish and void the warranty. Stainless steel should be cleaned as often as necessary to prevent films or deposits which may eventually cause corrosion – from settling upon the surface.Whenever possible rinse thoroughly with clean water and a soft cloth and blotdry completely. Ordinary deposits of waste and fluids can usually be removed with mild soap and water and a soft cloth. Never use cleaning products containing abrasive cleaners, ammonia, bleach, acids, or chemicals as these can damage the finish. Allowing salty solutions to evaporate and dry on StainlessSteel may contribute to corrosive conditions and should be avoided as this will destroy the finish and void the warranty.
Please check my other items...
We do not accept responsibility for any problems that may occur through incorrect installation.
To maintain the appearance of this fitting, ensure it is cleaned only using a clean, soft damp cloth. A solution of warm water and mild liquid detergent may be used where necessary, and then the fitting rinsed thoroughly. Abrasive cleaners or acidic cleaners MUST NOT BE USED under any circumstances.
FAST POSTAGE - FIRST CLASS ROYAL MAIL
WANT IT FAST- please choose special delivery at the checkout
ANY QUESTION- FEEL FREE TO ASK