I know this is obvious, but you MUST have an FX Wildcat airgun for this accessory part to fit -- since it is designed specifically for the Wildcat's stock. And of course, the gun is not included.
Also, this item fits the original gray stock AND all of the laminate and wood stocks.
As seen on YouTube!!! Video about origin and features: HERE
This holder requires no holes or alterations to your stock in any way.
Magazine holder for FX Wildcat airgun holds three magazines in the stock of the gun. A fourth magazine can, of course, be stored in the breach for a total of four magazines that can be carried with the gun using this holder.
Magazine holder is a durable, PLA plastic clamshell assembly that mounts in the rearmost hole of the FX Wildcat stock with a retaining screw and bolt and two self tapping screws (all parts included). Once installed the unit is very secure.
The clamshell sides have vinyl bumpers along their edges to help prevent the clamshell marring the stock finish on assembly into the gun.
Once the holder is installed, .177, 22 or .25 caliber 8-shot magazines snap securely into place in the magazine holder with a satisfying "click" just like they do into the breach of the gun.
I have made bunch of these, and my intention is to ship quick. There may be a bit of delay if demand exceeds supply, but check my feedback -- I pride myself on shipping as fast as I can.
I will ship these anywhere in the world via United States Postal Service and associated worldwide carriers. Check the shipping options above. The reason I am using eBay is so that I can ship anywhere easily,
Installation instructions:
Tools you will need: #0 or #1 Phillips head screwdriver (a.k.a. a smaller-headed one).
IMPORTANT: Over tightening screws will destroy your holder. Follow directions closely!
Magazine holder comes assembled, so it must be disassembled to be installed on the rifle.
Once disassembled, you will have one screw and nut pair and two self tapping screws.
If you are worried about the holder rubbing against your stock once installed, you may add electrical tape to the stock around the three turns of the hole before installation. One 2-1/4" and one 1-3/8" piece will do.
Place the larger piece of the clamshell into the buttstock hole on the breach (cocking) side of the the gun and hold the nut in place with your thumb.
Next place the smaller clamshell piece on the opposite side of the stock and press the two clamshell sides firmly together into the buttstock hole.
Be sure that the gap between the clamshell pieces is closed to at least 1/16" in the middle and at each end.
While pressing together, insert the screw opposite the nut AND JUST GET IT STARTED. The two sides will need to have less than 1/16" gap for the screw to begin binding on the nut.
Without tightening the nut all the way, insert the two self-tapping screws into each end (where the holes are). Tighten these tapping screws ONLY until they are flush and the gap between the clamshells is completely closed. DO NOT OVER TIGHTEN.
Finally, finish securing the screw/bolt in the center until that gap is closed -- taking care NOT TO OVER TiGHTEN.
Assembly is complete.
Please Note
These are built in small batches in real-time based on orders received. Above you will note that eBay says I have "so many" available, That number is completely arbitrary and I have no control over it. The fact is that IF I have one built I will ship it ASAP. If I do not, it will go out just as soon as it can be made. These are all built in my shop by hand with the help of a very finicky 3D printer. As you can tell, people really like these -- all I ask is that you are patient if I have a hiccup in production. I will always keep you informed if shipping is delayed by more than about 5 business days. And please check out my feedback -- most people get them very quickly.