Developed from the ground up, we wanted to build a truly Multi-rotor specific ESC that would offer the best performance and value in the market today. We wiped the slate clean and looked to the community for inspiration and help in designing an ESC that truly could be known as “The Multi-rotor ESC”

Enter Simon and Hamasaki AKA SimonK and timecop.

Boasting high efficiency, all N-channel MOSFET design, jitter-free hardware PWM input, and smooth power response the Afro ESC series are set to change the expectations of multi-rotor pilots around the globe. The Afro ESC series ship with multi-rotor specific SimonK software preloaded! No need to reflash. For added convenience the Turnigy USB linker can be used via the PWM signal lead for any future software updates eliminating the need for complicated flashing jigs or the need to cut open the heat shrink.

MikroKopter I2C compatibility has also been built in as standard. A DIY port is available under the shrink wrap which allows using the ESC with MikroKopter hardware that uses I2C control.

• Now Shipping with OneShot125.

Specs:

Current Draw: 12A Continuous

Voltage Range: 2-4s Lipoly

BEC: 0.5A Linear 5.0v

Input Freq: 1KHz

Firmware: afro_nfet.hex

Discharge wire/plugs: 20AWG/Male 2mm

Motor wire/plug 20AWG/Female 2mm

Weight: 10g (Included wire, plug, heat shrink)

Size: 25 x 20 x 6mm