CHROME 360 Degree Recessed PIR Ceiling Occupancy Motion Sensor Detector Light

BEST PIR 360 deg on the Market.. Infrared motion sensor suitable for 220V/240V( only) Toilet, Bathroom, Kitchen, Alley Way, Corridors, Extractor Fans Auto switching Energy Saving. The product adopts good sensitivity detector, integrated circuit. It gathers automatism, convenient safe, saving-energy and practical functions. It utilizes the infrared energy from human as control-signal source, it can start the load at once when one enters detection field. It can identify day and night automatically. It is easy to install and used widely. SPECIFICATIONPower Source 230-240V/AC Detection Range 360° Power Frequency 50/60 Hz Working Temperature -20~+40°C Ambient Light 3-2000LUX Working Humidity <93%RH Time-delay10sec±3sec to 7min±2min Installation Height2.2m~4m Rated Load1200W (incandescent lamp)300W (energy-saving lamp) Power Consumption 0.45W(work) 0.1W(static) Detection Distance6m (<24°C)(adjustable) Detection Motion Speed 0.6~1.5m/s Detection Range: 360 degreePower Source: AC 220-240V/AC Power Frequency: 50/60HzRated Load: Max.1200W (220-240V/AC) Detection Distance: max.6m (<24℃) Time Delay:10sec to 7min(adjustable)Ambient Light :3-2000LUX(adjustable)Detection Motion Speed: 0.6-1.5m/sInstallation Height: 2.2-4mSize of PIR: 55mm from the ceiling and cut out 65mm.Technical parametersFUNCTIONIdentify day and night automatically. Can adjust ambient light according to your desire: when turn to SUN (max), it will work in the daytime and at night. When turn to MOON (min), it will only work under less than 3LUX circumstance. Time-delay is added continually: when it receives the second induction signal after the first inductor, it will compute time once more on the rest of the first time-delay basic (Set time) .Time-delay adjustment: it can be set according to your desire. The minimum is 10±3 sec; the maximum is 7±2min.INSTALLATION:Turn off the power.Remove the transparent vinyl cover That is in the bottom of the sensor.Loosing the screws in the connection terminal, connecting the power and rated load to connection terminal of sensor according to connection sketch map.Tighten the screws; put the transparent vinyl cover into the original station.Fold the metal spring of the sensor to upwards, until they are in “I” position with sensor, then put the sensor into the hole or installation box what is in the ceiling, the size is similar with item. Releasing the spring, the sensor will be set in this installation position.After finishing installing, the sensor could be connected the power and testing it.