Tube preamplifier built using high end audio parts, a commercially available L2 Tube Preamplifier line stage board, and a with point-to-point wired phono stage according to a L2 phono schematic. The power supply is a solid state triple CLC filter type for quiet operation.  If you like the sound of tubes, especially those made in the USA, but hate the glitchiness and noise of old gear, then this is the way to go. This is not a kit amp, it was professionally designed and built. Line stage board manufactured by ANK.

Sample parts include Mundorf caps, Elna Silmic II eletrolytics, Nichicon film and High Temp capacitors, WIMA MKP10 Germany polypropylene film capacitors, Mallory 150 Series caps,  WBT German silver solder, GE long plate matched 12AU7 tubes, L2 phono stage point-to-point wired, GE vintage US tubes with heavy-duty tube bases.

Solid state Toroidal transformer power supply with extra filtering and US Made sheet metal shield for very quiet operation. 

All aluminum New Jersey, US made chassis.

Solid aluminum milled set-screw knobs.

All CAT6 copper in Teflon signal wiring.

Series 27 ALPS Japan volume pot with mounting board.

3 line level and one phono inputs.

Abundance of gain both on line and phono stage.

Will be carefully packed and insured for shipping.

Tube compliment:

Line Stage: GE Long Plate NOS Platinum Matched 12AU7 x2
Phono Stage: GE 12AU7 and mistery USA 12AX7

Please note a tube preamplifier must be turned on first and allow a few seconds to stabilize before turning on the power amp. Turning on the power amp first and then the preamplifier can lead to damage to sensitive speakers because of the DC pop.  If you are not willing to follow this process carefully, get an integrated amplifier instead.  Pre first on, last off.  Always.