Following the Success of the Team Dogz Rainbow Scooter, we've launched our very own mini BMX. Featuring our stand-out rainbow finish and boasting the best parts the industry can offer, this is probably the best mini bike on the market! 
Whether you're just in search of something to have a little fun on, or you're aiming to turn mini BMX pro, this is for you! Fill your down time with hours of fun and join in with the latest skate park craze now!

Specs:

• Hi Tensile 10” Full Chrome Rainbow Frame.
• Hi Tensile Super Strong Rainbow Bars (10” x 28”).
• Toughened 3 piece Chromoly Cranks.
• 28 Tooth Sprocket (28/9 gearing).
• 9 Tooth Rear Driver with loud cassette.
• Soft Flanged Grips (140mm).
• Sealed Bottom Bracket.
• Super Lightweight Plastic Pedals.
• Lightweight Alloy top load stem.
• Threadless CNC Forks and Integrated Headset. Top bolt adjustable.
• Quality Chrome chain (1/2 “x 1/8”).
• Original Mini BMX 10” Chunky Tyres (4.1/3.5 – 4).
• 2 piece Rainbow Wheels with 6200Z Sealed Bearings.
• Team Dogz Water Transfer Logo.

 What You Get

• Mini BMX
• Manual / Assembly leaflet
• Allen key
• Spanner

NB Some assembly required: 


We strongly recommend that customers inspect all parts before installation and check pre-assembled parts over before riding. 

Installation of Handlebars
Begin by removing all packaging and standing the bike upright. Where the handlebars would normally be attached to the stem you’ll notice four bolts holding in the stem clamp (the plate on top), these should be removed along with the stem clamp itself.   Next, place the bars upright in the corresponding channel (ensuring they are facing the correct way- the grips will sweep backward ever so slightly) and place the stem clamp back over the top. Holding the bars in place and in a central position, tighten each bolt evenly until the bars can hold themselves up but are still able to move. Adjust the bars to your favoured position and tighten the bolts up as much as you can, remembering to tighten them evenly. 

Installation of Pedals
Start by identifying which pedal is which- you’ll find either an ‘L’ or an ‘R’ on the end of the threaded part of each pedal. Looking from the back of the bike, install the pedal with an ‘L’ on the left and the pedal with an ‘R’ on the right. This is done by feeding the thread into the hole on the end of the crank and using the spanner provided to turn the flat part of the threaded bolt anticlockwise until tight. 

Installation of the Front Wheel
Attach the front wheel by inserting the axle bolt horizontally into the slots at the end of the forks, you may need to loosen the nuts on either side to be able to do this. Once in place, tighten each nut onto the outside of the forks until the wheel is held in place securely and cannot move laterally. 

Installation of the Saddle 
Simply insert the seat post, under the saddle, into the seat tube and tighten at the correct height using the pre-installed pinch bolt. Please ensure that at least 5cm of the post is inside the seat tube. 
 
Please note you may need to pump up the tyres before use. This can be done using the valve on the wheel.  Please ensure they are solid so as not to damage the wheel. Recommended 30PSI.