Arduino Stepper Control Board
with manual control
Arduino Stepper Pilot Board
Potentiometer for speed.
2 Push buttons.
Slider switch for direction selection.
More information on this wiki page
12V power supply. (30V max)
2.1mm DC power socket connector.
i2c port
FTDI (serial uart) port
Sold flashed with a basic sketch to run the motor at various speeds. Download default Sketch.
NOTE: A programmer board is required to program the Atiny84 with Arduino IDE. We do sell these programmer board. Enquire within or check other items for sale.
This is an example of application below. Driver and motor are not included in this listing.
The mode of operation of this board is similar to our other A4988 control board shown on the video below.
Stepper Motor driver board with Attiny84 mcu.
This stepper control board has been designed to offer ready to use manual control for your stepper motor. An Attiny84 microcontroller is used which means that you can change the firmware yourself to program the board. This is using Arduino IDE. Other options are possible such as using the board with serial or i2c communications.
Compatible with many stepper drivers such as tb6560 and JK series.
Manual Controls:
More information on this wiki page
NOTE: A programmer board is required to program the Atiny84 with Arduino IDE. We do sell these programmer board. Enquire within or check other items for sale.
This is an example of application below. Driver and motor are not included in this listing.
The mode of operation of this board is similar to our other A4988 control board shown on the video below.