--For
best results please use the wet method bellow when applying the decal--
Wet
Method
Supplies
needed-
·
Spray bottle filled with a light
solution of soapy water (only a few drops of soap)
·
Hair dryer
·
Lint free cloth
·
Squeegee (or credit card will work)
1. Clean
the area where the tint is going to be applied. Make sure the headlight is free
of any foreign material.
2. Remove
one of the headlight tint overlays and soak the backside of it with the soapy
water solution.
3. Begin
to apply the tint overlay, sliding it around until it is centered on the
headlight.
4. Once
you are happy with the alignment, apply light heat from a hair dryer until
enough water is removed for the tint to hold its position.
5. Begin
to lightly squeegee the excess water out from under the tint. Make sure to squeegee
out any major bubbles. (small bubbles and milky white color behind the tint will dissipate over time)
6. Apply
more heat if necessary
7. Repeat
the same process to the other side
8.
It is best to allow at least 12 hours of dry time before driving the
vehicle. This will insure that the decal sections will not slide out of place. It may take a couple of days for all the moisture to dry out from behind the tint.
-- If you
have any questions or issues installing the item feel free to contact us. –
Maintenance
-
Take precaution when washing the vehicle with a power washer or high
pressure hose. Do not spray in the area of the tint; it could cause the tint to
peel up.