If you have made the move from the Jeep XJ to the Jeep ZJ you know the Jeep Grand Cherokee's off-road capability and heritage, but you also know that it needs some stability. Put your mind at ease! The need has become too loud not to fill. Check out D and C Extreme's 6-point Jeep Grand Cherokee roll cage kit.

The Jeep ZJ kit is built to be a massive reinforcement to the stock uni-body while giving you all the room you need to get in and out and store your stuff. In designing the Jeep ZJ roll cage kit we stressed the importance of keeping ample head room in the front and rear. D and C Extreme prides itself on the quality, fit, and finish of our Jeep ZJ kits. Not only do they cover you, they don't get in your way. When properly installed you should be able to use ALL your handles and knobs (1992-1998 models have some obstruction on the glove box). Precision bending allows for massive amounts of head room and a 100% usable rear seat (for kids AND adults).

From the outside these kits are virtually invisible (drawing no unwanted attention to your built Jeep Grand Cherokee). On the inside you are able to leave your interior intact.

These kits come with:

• 2 front spreaders
• 2 rear spreaders
• Main hoop
• Seat belt bar (behind front seats)
• Dash bar (above gauges)
• Windshield bar (top of windshield)
• Rear lift gate bar (top of lift gate)
• optional 8 point tie kit (adds another hoop over the back seats)

This cage is built using 1.5" DOM 

Although we've done everything we could to avoid it, some slight trimming may be needed for assembly, however, it is rare.

Disclaimer:

All cages come as kits and are not assembled. Welding is required on all kits and options. Welding should be done be a competent & certified welder. Although D and C Extreme has made every effort to make our cage kits as strong and easy to properly install as possible, we can not perform the install on all kits. Therefore, we will not (and do not) guarantee the performance of any cage kit in event of a roll over. Drivers of lifted or modified vehicles need to exercise extreme caution when operating said modified vehicle.  Some minor trimming may be needed for exact fitment, but we do everything we can to avoid it.

A Word about Welding:

This product requires installation by an experienced welder, using high-quality welding equipment and supplies. If you are not a qualified welder you should hire a professional/certified welder from your area. Welding this product should only be done with a minimum 220v/175a MIG Welder and .035 wire.