Headphone amplifier HP100 - PCB board
Beautiful headphone amplifier in Single Ended class A. Best sound in the world. Our design is simply clever with high quality parts like a DACT, Alps, Wima, Solen....
In our construction we use BB OPA627 and Japan bipolar transistors with high currrent output and slew rate! Also you can see very low distortion on the picture.
This amp is made and design in the Europe - Czech Republic. No China!!!
This amp was born for one customer wich use headphones HD800. Now you can buy it like assembled or no-assembled kit!
The sound is clean, natural and so open. So just buy it and enjoy it.
THD: 0,00014%
THD+N: 0.0024
S/N: better then 120dB/2,0V RMS
Maximum Outputl Voltage: 10.0V RMS/5Hz - 200KHz/ 0,0024% THD+N
Maximum power output: 1,0W/ 24Ohm/ 0,0024 THD+N
Frequency char.: 5Hz - 200KHz / -3dB
Recommended Impendance: 24-600 Ohm
Recommended Headphone: Bayerdynamic T1, DT880 or 990, Sennheisers HD800, HD600, AKG701
Our Company Analogservis has more like 20 years experiences with design amplifier and preamplifier.
We offer DIY kits:
Level One: 60.00USD
High quality 2mm PCB boards 0,70um print copper
Manual + schematic circuit
Level Two: 300.00USD
Complete kit with all parts
High quality 2mm PCB boards 0,70um print copper
potenciometer ALPS
Hammond case with original front and rear panel
Japan Toshiba transistors
1% metalic resistors,
Original OPA627
Panasonic and wima capacitors
Talema power transformer
Manual + schematic circuit
Level Three: 500.00USD
Full assembled amp with high quality parts like in the level two with 5 years guarantee.