This is an Epicure Model one 125 watt per channel stereo power amplifier. This unit is in good working and cosmetic condition. This is a very nice sounding hi end power amplifier from the 70's In The pics you'll see the high temp lights both light with the test switch and you can also see the high voltage lights lit with the test switch. The amplifier works well, I've had it for years and it's always been dependable. The only thing I've noticed is somebody in it's past has bypassed the volume controls. But it never bothered me because I didn't use them anyway. Good solid piece That I think you'll enjoy. Thanks

Specifications

Dimensions: 18 1/2" x 12 1/2" x 7 1/2"

Weight: 58 lbs

RMS Power: 125 watts rms into 8 ohms,

both channels driven 20-20,000 Hz

at or below 0.2% THD or IM

(typically over 150 watts)

Total Harmonic Distortion 0.2% rated, typical below 0.05 into 8 ohms

IM Distortion 0.2% rated, typical below 0.03 into 8 ohms

Frequency Response 20 to 20k Hz, +0, -0.1 dB

10 to 100k Hz, +/- 0.5 dB

10 to 180k Hz, + 0, -3 dB

Rise Time Better than 1.5 microsecond

Damping Factor 100 or greater

Slewing Rate > 17 v/microsecond

Signal to Noise Ratio > 100 dB at full output, typical > 110 dB

Phase Response maximum deviation 15 degrees

  20 - 20k Hz into 8 ohms

Input Impedance 10k ohms (input level at maximum)

Input Capacitance 50 picofarads

Input Sensitivity 1 volt for 125 watts

Stability Unconditionally stable from short to open

MSRP: 600.00 - 649.00

Built: 1973...