6 x Mixer fader knobs for Pioneer DJM 300 500 600 3000

This is a set of knobs to replace each fader/slider knob on the Pioneer DJM 300, 500,600 or 3000 series of mixers. They are not identical to the original knob, however are very similar and look great when replaced as a set.

They have a tight fit onto the fader stem, so are not easily lost when the mixer is used at parties or in a club. However - do not apply great force as you may damage the fader.

Fitting note: Due to the tight fit and varying component tolerances, you may find the knob does not fit all the way down the fader lever. This can be remedied by removing a small amount of metal from the fader lever (either side and top) with a file. Use a piece of masking tape to seal the front of the mixer to avoid any metal swarf entering the fader. Alternatively, remove a small amount of plastic from the inside of the knob with a 1.5mm drill. To fix permanently in position, use a dab of hot glue or a very small amount of epoxy resin.

Not suitable for DJM800.