Jeti Rex 6 JBC 35 Mhz 6 channel receiver which can be programmed using the Jeti BOX. For use with standard size crystals. The JBC (Jeti Box Compatible) receivers make it possible to achieve infinate mixing and control throw options, though it is far quicker to use the pre-programmed options for V tail mixing, elevon mixing, coupled rudder and nose wheel (with movement reduced to 60% on the nose wheel), coupled aileron and rudder, coupled flap and elevator, flaperon mixing, and elevator trim for flaps. The receiver is suitable for receiving signals from Futaba, Hitec, Multiplex, JR, and Graupner/JR 35Mhz transmitters, though the pre-programmed mixing options are set for the Futaba/Hitec output numbering.

Other features include the recording of receiver battery voltages, number of bad signals received during the last flight, and fail safe with the option of inputting the fail safe delay.

Programming is achieved by selecting one of 5 headings (that give basic data about the receiver attached), and then scrolling down through the pre-programmed options. The option is saved by holding down both the left and right buttons for 3 seconds. There is an option to return the receiver to factory settings. Technophobes may prefer to use the receiver as a normal and very cost effective receiver straight out of the box!

The case is moulded to receive Futaba type servo leads, and can also be used with Hitec/JR type Uniplugs.

Compact and lightweight 6 channel 35Mhz receiver.

Requires a Futaba or Hitec single conversion receiver crystal.

The JBC range feature microprocessor signal decoding to give the cleanest possible output from even the poorest signals.