User's guide [ EN ]
User's guide [ ESP ]
User's guide [ PL ]
Specification:
Supply voltage (V) 7 – 35V DC
Input LOW voltage 0-10V DC (from cuter voltage divider 1:50)
Input HI voltage 20-300V DC
Ability of HV/HF ionization voltage suppressing 30kV
Ability of HV/HF ionization frequency suppressing >100kHz
Duty cycle (%) 100%
Duty cycle of HV / HF suppression (%) 100%
Rated max. load 1,25A / 60V DC
Relay reliability (minimum amount of cycles) under load of 5V / 10mA : 500*10^6
Degree of protection of enclosure IP IP20
Weight (g) 180g
Dimensions (width*length*height) 33*89*65
Mounting DIN 35 rail
country of origin : POLAND
Example for MACH3 DEMO configuration :
This device connect to your system the same as home switch, e-stop etc, the connect diagram is dependent on your system.
Before buy you can test your system with switches connected to your system - you simulate the thc up/down signals and make sure that this device will work with your system properly.
Example for Plasma-Voltage connection
PLASMA CUTTER WITH VOLTAGE DIVIDER 1:50 OUTPUT :
PLASMA CUTTER WITHOUT VOLTAGE DIVIDER OUTPUT :
Example for connection ( arc ok signals isn't require )
Example for Gecko540 driver connection
Clients VIDEO (old version without 1:50 divider input)
Worldwide support via e-mail or MSN:
Shipping from Polish to European Union : Registered mail (tracking).