Lock Head Gyro for Esky EK2-0704B 000855 Belt-Cp CX CPX King 2 King3 King4 K3 K4

Specification:

Input signal:1.5±0.5ms

Input power: 5~6VDC

Weight: 12.5g

Size: 27 x 28.5 x 18mm

Feature Illumination:

can be used on Engine and Electric Helicopters

dual sensibility adjusting - nose locked model and standard model;

suitable for 4ch and 6ch transmitter;

with a built-in temperature equalizing electrocircuit;

to both 6CH and 4CH transmitters, the gain value can be adjusted through crust

Installation:

the headlock gyro must be installed horizontally (LED faces upward)

For ESky Belt-CP and Honey Bee King 2, please make sure it is at "NOR" position

the headlock gyro (3pins) cable should connect to the channel 4 on the receiver

the tail servo should connect to the headlock gyro (black wire near the edge)

Servo Limit on the gyro about 10%

Delay Switch on the gyro about 70-80%

you can choose not to connect the single orange cable to channel 5 on the receiver. if the gain of the headlock gyro > 50, it is in the headlocking mode. If gain < 50, it will be in the normal mode

please tie up all the cables before fly, this is to prevent loose cables to touch the main gear or motor

the photo shows only an example on how to mount the headlock gyro, you may choose to mount it on the main body of the helicopter.