TIP:- T-style inserts are first choice for internal longitudinal turning as this style of insert uses an entering angle at 91 degrees. This helps to direct the cutting forces correctly. You also get 6 cutting corners with these inserts! Buy it Now 1 Brand New Pack of 10 Sandvik Carbide Inserts TNMG 221-QM TNMG 110304-QM GC4225 QM Chip Control Geometry - for medium turning with all-round capability in steel, stainless steel and cast-iron The QM geometry provides sufficient edge strength when machining difficult-to-cut materials while also enabling effective chip control which breaks the chips into really nice sixes & nines. These are easy to evacuate eliminating the risk of swarf-clogging and also do not place such large stresses on the cutting edge when chipbreaking occurs. In addition, compared to other typically applied PVD coated grades' 10% Cobalt content, Sandvik 4225’s MTCVD coated carbide grades have 12% Cobalt. As a result, they perform very well when cutting difficult-to-machine materials, partly because of their higher toughness Components : generally within mixed machining of steel, stainless steel and cast-iron Advantages : large application area for semi-finishing to light roughing in different materials General recommendations : alternative solution to geometries PM and MM, when more machining stability is needed and alternative solution to geometry KM when a lighter cutting action is needed
All Items are generally shipped Free to Anywhere in the World through Registered Post/Parcel by Airmail unless stated/or requested for Expedited Shipping which will be through DHL. So please be sure to check my other Items too... Satisfaction Guaranteed! No Negative, Neutral or even a Revised Feedback, Ever!!! Buy with Confidence and a Full Peace of Mind! If unsatisfied for any reason, just let us know and upon discussion, we will refund you the full amount on return of the Item plus the incurred shipping cost. |