Fender Twin Reverb II Head
105 Watts All Tube, point-to-point hand-wired
1980's Rivera Design
- In good working condition - great Fender tone sound - tank reverb
- Everything original - Except for tubes (of course): 2x 6L6GC Raytheon England (great sound), 2x 6L6GC JJ, all JJ preamps.
- Top corner of cab has a crack repaired with stitch nails - solid
- No back plate cover
- Of course, speaker cabinet in pics is not included :)
- Frankly, where can you get a point-to-point hand-wired, all tubes, over 100 watts amp head for under $1,000 ?
In 1982 the Twin Reverb II was introduced to compete with Mesa Boogie's very successful products; it had an output rating of 105 watts and a return to Blackface era cosmetics albeit with a different, channel-switching cascading gain circuit with a more modern mid-range voicing and without the 'traditional' vibrato. The Twin Reverb II was produced until 1986, and was available as a head (amplifier alone) or 2×12 combo. The circuits for this series of 1982 Fender amplifiers were designed by amp guru Paul Rivera. All Reverb II models in this range and the next are now becoming highly sought-after by collectors and players.
Faceplate
- Front: In 1, In 2, Vol (Pull for Bright), Treb, Mid, Bass – Vol (Pull for Ch Select), Gain, Master Vol, Treb, Mid (Pull for Boost), Bass, Reverb, Presense – Standby Sw, Power Sw, Pilot Lamp
- Rear: Fuse (4A), AC Outlet (Grounded, Polarized), Ground Sw (A/Off/B), Speaker (1/4”), Ex Speaker (1/4”), Line/Recording (1/4”), Output Matching, Return Level, Return (1/4”), Send (1/4”), Send Level, Reverb Out (RCA), Reverb In (RCA), Pedal Plain (1/4”), Pedal Red (1/4”), Hum Balance
Effects: Reverb, Channel Switching
~Watts: 105 watts - 8-ohm
Tubes
- Pre amp: 5 x 12AX7 2 x 12AT7
- Power: 4 x 6L6
Bias: Fixed
Rectifier: Solid State