This is a replacement LCD module for Logitech's Harmony One remote control (Ver 7.4 PCB ONLY). It is slightly smaller in size (2" vs. 2.2"), than the OEM module, but it renders beautifully and is much more durable and less prone to breakage than the original module. This replacement LCD module is only compatible with the 2nd Generation Harmony One (PCB version 7.4) and it will not work with older versions of the logic board. If you are not sure which version of the hardware you have, you can send me a message with the PID or S/N number and I can usually tell which hardware board you have. The PID/SN is located on the label that is visible when you remove the battery door cover. PID's typically begin with WD, LZ or LV. S/N's begin with the #1. The LCD comes with an installation kit to make removal of the old LCD, and installation of the new one, easier. The kit includes the following items:

                  • Triangle pry tool (1)
                  • Kester 63/37 solder coil (8”)
                  • ChipQuik de-soldering alloy (1/2”)
                  • ChipQuik No-Clean Paste Flux (2cc)
                  • Soder-Wick copper de-soldering braid (2”)
                  • Foam Strip (light 'blocker')
                  • Q-Tip (2)
                  • Round Tooth Pick (2)

Please note: You need soldering experience in order to successfully install this LCD module and it is highly recommended that you have previous experience working on SMD components. Ideally, you have worked with FFC on a prior occasion. This is not the same as soldering speaker wires or doing large through-hole work. It is recommended to view the installation videos that have been posed on YouTube