Here is another Cutawl item brought to you from 1st-Award, your eBay source of guaranteed used Cutawl saw kits!

This lot of #11 chisels is unused stock.  The #11 chisel is designed to utilize the best features of the Cutawl saw, cutting very smooth lines and patterns in soft sheet goods such as white board, cardboard, leather and other similar materials.  (A more complete list of materials is at the bottom of this listing.)  This blade is made of extremely strong high carbon steel with a chisel point and sharp side.  Moving up and down 50 times a second, it will move easily through your material.  Your cut edge will be finished and will not require additional working to smooth it.  This may be the most versital blade of all Cutawl blades.  You may start your cut any where on your pattern with this blade because of the chisel point.

 

The materials for which this blade is designed (with maximum thicknesses in parentheses) are as follows:  canvas-(11/16"); cardboard (11/16"); Celotex (11/16"); Cornell board (11/16"); corrugated board (11/16"); cotton cloth (11/16");  felt (11/16"); Homosote (5/8"); leather (1/2"); Naugahyde (11/16"); paper, crepe, kraft and tissue (5/8"); polyethylene (11/16"); rubber, spunge (11/16"); rugs (1/2"); Upson Board (11/16"); wallboard, Sheetrock, etc. (1 1/4"); wood fiberboard (11/16"); and wool cloth (5/8").  Other materials of a similar nature to these may also be cut well with this #11 blade.  Do not exceed the maximum depth of sheet goods listed above at any time.

NOTE: The top of the blade must NOT rise above the top of the chisel block.  See the instructions provided with your Cutawl for stroke and clearance adjustments.  You will see case hardening colors and rust staining on some blades.  Such markings are not defects in the blades.  Because of their high carbon content and specialized heat treatments, these blades are always susceptible to rust staining if not kept well oiled and in a dry location.  Some Cutawl blades have been blued with gun finish (as in the blade above) and some have been made with stainless steel to minimize rusting, all with minimal success.  Seconds after cutting into any material, the rust staining and surface treatments will wear away and you will have a nice shiny blade!

Thank you for viewing my sale!