You are purchasing one

SkyMAX Wind and Solar™ 
12 Volt 10,000 Watt 441 Amp Smart Charge Controller 
for Wind Turbine Generators with Digital LED Volt Meter
Works with solar panels also


  • Dual microprocessor controlled for stability and accuracy
  • Multiple user changeable settings and trip points for many various system requirements and applications. 
    • You can change the dump point voltage level, end of dump voltage level, and length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes)  
  • Isolated Electronics Protection - Almost impossible to accidentally connect wind or solar directly to the circuit board
  • On board relay isolates electronics from back voltage spikes from large 440 amp relay. This is important to get the longest life out of the electronics.
  • High amp rating: 440 amps, 10,000 watts.
  • Battery Status LED lets you know your battery's actual voltage!
  • Green LED on board lets you know the controller is in dump mode
  • Plug & Play: Long leads for easy termination to your 12 volt battery or battery bank
  • Can divert the charging source from the batteries to the load or dump both the batteries along with the charging source.
  • Connect both wind and solar at the same time
  • Reverse polarity protection
  • Ultra low power consumption, even with the volt meter on (almost negligible).
    • The volt meter can be set to turn off after periods of inactivity.




    • The 440 amp charge controller with divert relay can be used with our divert loads (divert load sold separately). Some diversion loads include, wirewound resistor style, DC water heating elements, our room heaters, or simple plug in grid feed inverters.

    This 440 Amp 10,000 Watt diversion controller features an LED display to let you know the battery voltage.

    About load diversion:

    The basic operating philosophy of a diversion controller is quite simple. Monitor the battery voltage, and if it should rise to a predetermined level, connect a diversion load, of sufficient size, to the battery or energy source to prevent the battery voltage from increasing any further. This is a very simple, yet very effective way of preventing battery overcharging. All alternate energy systems should have some form of battery overcharge protection.

    Several schools of thought on the subject:

    1. The source of power (wind turbine, solar panels etc.) -- should remain connected to the batteries while the dump is active.

    2. The source should be diverted to the load directly and disconnected from the batteries. We happen to believe that is far better to leave the wind turbine connected to the batteries at all times.

    Why? When you remove the battery level voltage from a wind turbine and send it's power directly to a load, then it sees for all practical purposes a short circuit (depending on the resistance of the load and lead wires.) This may cause the turbine blades to slow dramatically and in some cases bring it to a halt. This braking action can cause heat build up in the stator if it is repeated every few seconds or so (if the battery is just a little over the top). When you allow the turbine to see the batteries, along with the load, the turbine remains more within it's design realm -- always a good thing. The internal relays are configured to dump the batteries along with the source, but if you desire to disconnect the source from the batteries and send it to the load directly, simply utilize the N/C contacts of the relays as well. 



    We do not mark items as gifts or under report values for customs. For International buyers,

     it is strongly recommended to check your own country's tax practices as we do not 

    pay your taxes, duty or customs fees.

    We do not over charge for shipping; it is simply what the shipping calculator comes up with. 

    Customs fees or taxes are not included in shipping, it is your responsibility to pay them.


    For ALL UPS orders, we only ship signature required!! Contact us right away if you need to make other arrangements!

    On Mar-24-15 at 10:51:16 PDT, seller added the following information:

    Products may be slightly different than the ones pictured. If our supplier runs short of the products shown, we will substitute them for the same quality or better.