​FINALLY!
Replica 1936 Knuckle FRAME
a close reproduction of the HD factory first year only Frame for the 1936 Knuckle
Frame has forged steel parts: neck, front and rear motor mounts, top seat yoke, footboard tabs and rear axle plates
Exact blanked and formed steel stampings are utilized in appropriate areas
Rear fender cross bar is supported by exact duplicated “saddles” brazed at each end
Seat post bushing, brake cross shaft bushings, and grease fittings are installed
The Frame has a 28° neck angle, correct rectangle tool box pads, and 7/8" diameter tank brace
Rear brake tab support slot is open like original
Front down tubes curve like original first year Knuckle and have the side car loops brazed on
As was designed on original 1936, Frame does not have the outer 5th support bracket for transmission
Knuckle & UL Motors will fit this Frame without modifications
Now is your chance to build a replica of a historical 1936 first year OHV Harley Knucklehead  with originals selling for over $100,000!
FREE UPS SHIPPING TO THE 48

Out of country buyers contact us for shipping info