Beschreibung:

Super Preis-Leistung: 7 Kanäle + PPM + Satellit + voll Spektrum kompatibel für unter 20€.....(benutze ich selber mit meiner Spektrum DX6 und läuft bestens👍)

Markenname: Redcon

Einzelteil Name: CM703 2.4GHZ 7CH DSM2 DSMX kompatibler Empfänger

Band: 2.4 GHz 

Kanal: 7 + PPM Ausgang

Betriebsspannung: 3.3V-9.6V

Abmessungen (B x L x H): 47 x 24 x 14 mm

Gewicht: 10 g (4.8 g Naked)

Antennenlänge Haupt RX: 13.5cm (2)

Modulation: DSM2 / DSMX

PPM Ausgang: Ja (Unterstützung RC Multicopter) 

Kompatible Sender: JR und DSMX Spektrum DSM2 Sender

Eigenschaften:

7 Kanäle + PPM Ausgang

3dbi Gain Antenne, 15DBI Gain Verstärker.

Failsafe System

Sehr schnelle Verbindung

Kompatibilität (Spektrum und JR DSM2 / DSMX): DX6, DX6i, DX7, DX8, DSX7, DSX9, DX9 , DX11 , DSX11

Binding Procedure

I. Put the binding harness into connector location marked BIND. Next connect power to receiver. Receiver LED should illuminate it means bind is accomplished
II. To set fail-safe throttle and control surface positions, (minimum throttle and all control surfaces set to neutral is suggested). Press and hold the bind button of transmitter (LED will illuminate), Turn on the transmitter.

III. Receiver LED will change from rapid flashing to slow flashing and a few seconds later when bind is accomplished the LED of receiver will illuminate solid. Failsafe should be programmed correctly .

IV. Remove binding harness from the BIND channel. Restart the receiver by cycling it power off and turn on and connect battery into BIND channel is recommended. All channels should function properly now. You may test fail-safe by holding sticks in corner, cycle transmitter on and off. Surfaces and throttle should return to your preset fail-safe positions.

Notes: Only one time bind procedure is required on a new receiver. Repetitive binding provides no extra security. Always remember to remove the binding harness after successful bind is completed.

Lieferinhalt:

1XREDCON CM703 Empfänger

1XREDCON Satellite