"4L80E GM transmission cooler BANJO fittings" 

This auction is for one pair of -6 GM 4L80E transmission cooler banjo fittings.

People have been asking me to make some low profile fittings for the 4L80E so here they are.  These banjo fittings are under 1 inch tall.  The banjos and the bolts are steel, zink plated and come with aluminum washers.  You will want to inspect the surface of your trans case to ensure it's flat with no nicks / gouges that would prevent the washer from sealing.   

-6 x 1/4NPS is the correct thread size for the GM 4L80E transmissions. These fittings fit 1997 to mid 2010 cases.   It is always best to remove the factory adapters and measure the outside diameter of the threads.  They should be 0.521". 

In 1997 GM moved one of the cooler lines to the back of the transmission.  The front adapter is short and the rear is the longer one with the tube.  This is very crucial to the cooling circuit of the transmission.  So at the request of a fellow e bayer we ran a batch.  If you have a pre '97 unit the other GM transmission fittings in our store are what you need.  

Priced per pair with washers.

See our e bay store for stainless steel braided transmission cooler hose kits.  

NOTE:: The banjos are black anodized aluminum and bolts are Steel with a silver zinc plating.

"Hello Sweet performance,

I want to thank you guys for such a great product. Did a 4l80e swap on my 1995 toyota supra, and space was very limited. Used your banjo fittings, and it fit PERFECT. I had previously purchased the an fittings from you guys but stuck out too much once the line was installed.

Once again, THANK YOU.

Regards,

Cesar Enriquez"