| engraving machine new engraver double ended graver jewelry tool pneumatic impact | ||||||||||||||||||
|
||||||||||||||||||
|
Methods of operation: |
||||||||||||||||||
|
Methods of operation: |
||||||||||||||||||
|
1. The first pressure adjustment knob and rotate the handle switch shut down to avoid the pressure too great damage to the pressure in the table and the pressure relief valve. 2. power, turn on the power switch. (Light). 3. the position of the changeover switch is set to 1 or 2. 4. adjust the air pressure and speed, hand carved handle by stepping foot switch to adjust the pressure knob slowly. Pressure gauge indicates 1.5 ~ 2KG/CM2, adjust the speed knob at the same time, the combination of the two regulation carving handle the biggest impact, pressure adjustment knob is pressed. 5. the relaxing foot switch, carving the handle to stop working, as shown below loaded tool!. 6. size carved handle switch, turn the the conversion handle set and 2 and 1osition (should go to bits). 7. rotary engraving handle work, turn off the power switch, open the rotating handle switch, adjust the pressure knob. 8. hours of work with the footswitch opening increases smooth small to large control impact. |
||||||||||||||||||
|
Two handpieces, one large and one small. Speed is adjustable!. This is an impact engraver. It moves up and down due to a position. |
||||||||||||||||||
|
Specification: |
||||||||||||||||||
|
||||||||||||||||||