Get your coax TV or antenna signal extended for another 1300 feet or 400 meters away by using this premium signal amplifier.
The internal booster circuitry converts any low power, low frequency RF signal into higher frequency at higher power one but with super low noise. It overcomes the losses associated with in-wall installation from large building and boost the weakening or distorted data signal that occurs during long coax cable runs or due to the use of multiple splitters or multiple TV connections.
Supporting full TV channel frequencies from 50 to 860 MHz, which are widely used for CATV systems distribution, antenna system, RF signal improvement and CCTV multi-camera transmission.
Also served as a great solution for fixing the problems of noise, snowy picture, interference and weakness after distribution for CATV, Digital TV systems and CCTV systems. With the signal boost from this cable TV signal amplifier added in the setup, you can enjoy uninterrupted and improved picture quality that your TV will not normally receive with the available signal strength.
Easy Setup
Its setup is a breeze to install with
no tools are required. All connections are easy F-type coaxial ports, so
everything screws right in.
High Gain 32-dB Boost
This unit is featured with high 32 dB gain for all the RF input signals, which
literally means that the amplifier can help boost RF coax signal for more than
1300FT or 400m if RG-6 cable with 70/75dB signal strength adopted for the
setup.
The great performance of this device makes your CATV or antenna signal strength more than 50 times powerful in a snap. Users can easily extend the TV signal to greater distance for large-scale TV distribution so more TVs can be added in large office building or home residence.
This device also allows you to optimize multiple broadband devices in your home televisions, aerial antenna, cable TV set-top boxes, cable modems, DVRs, and digital FM radios, all from one convenient cable.
Easy Gain Control
The variable gain dial on this amplifier provides a variable attenuation control for reducing the possibility of over driving and
get best performance.
This great adjustment feature is very handy for installer to obtain the best setting of RF signal and for simple, quick signal level balancing and installation. Proper gain level can greatly enhance the picture quality with minimum noise and reduce noises found in existing RF cable setup.
Easy Slope Control
When installer has a large RF system to run or multi-transmission by one coaxial cable, this function of Slope Control is necessary to adjust all
coax signals to be transmitted to same output amplitude for optimal installation.
The slope of -20 dB compensation that this unit provides can allow large systems to be properly balanced and mixed with other CATV or existing RF distribution system.
Excellent Heat Dissipation
This amplifier is featured with robust aluminum die-cast chassis, which provides excellent heat dissipation and
long durability
Input Frequency Range | 50 ~ 860 MHz |
Output Max Level | 60 dBmV |
Maximum Gain | 32 dB |
Gain Control Range | 0 ~ -20 dB |
Slope Control Range | 0 ~ -20 dB |
Noise Figure | 7.5 dB |
Flatness | +/- 2 dB |
Return Loss | 18 dB |
Input / Output Impedance | 75 ohm |
Input / Output test point | - 20 dB |
Dimension |
|
Connectors | F type connectors |
Power Supply | AC 110V +-10% |
Power Consumption | 10 W |
Operating Temperature | -10 ~ 60 C |