transfer
GOLD foil
5
sheets A4 size, to be applied on sheets printed with LASER technology
printer
SIZE: A4
(210x297mm)
TYPE OF FINISHING: Metallized
GOLD effect
BOX: 5 sheets
THICKNESS:
12µ
FOIL CHARACTERISTICS:
- Metallic
effect decoration of printed sheets, both on paper and carton box
- Hot transfer
with laminator or iron
- Very limited
thickness
USES:
Decoration and
enrichment of postcards, greeting messages, business cards, boxes and other
objects printed with laser technology; allows transforming a simple print into
a decorative and elegant product
For great q.ty or different size than A4
standard, please contact us, we will make an offer adapted to your needs;
INTRODUCTION:
This transfer foil
does not need to be printed; the function of this sheet is to decorate printing
sheets previously printed using LASER printers.
The principle of
operation is very simple, the metallized film will be transferred based on the
amount of black present in the press.
Thus, for example a
decoration completely black (100%) will become, after the application of the
metallic foil completely covered by the film metallic effect.
In a product with
various shades of gray, the result will be a not complete transfer, with
consequently areas in which the metallic effect will be higher than others
will.
On unprinted areas,
the white areas, there will be no transfer.
HOW TO USE:
Print the desired
decoration on office paper or cardboard, making sure to print only in black and
white mode (it is possible to select this option in the graphic software,
and/or in the printer settings).
TRANSFER FOIL:
Take the printed
sheet and secure it to the metalized foil, using a bit of adhesive tape at the
top and bottom.
Fix the sheets in
order to have the printed sheet as the lower one, with the decorated side
upwards.
Above the printed
sheet place the metallic foil, placing it with the metallized side upwards.
Above the two
sheets position a sheet of siliconized paper (or common baking paper).
TRANSFER BY
LAMINATOR:
Pass the
"sandwich" of sheets in the laminator (temperature between 120 ° and
150 ° C, average speed).
It is possible to
perform rolling twice consecutively.
Remove the silicon
paper and, when the sheets will be completely cold, remove the transfer foil.
TRANSFER WITH IRON:
Place the
"sandwich" of sheets on a hard surface, set the iron at about 150 ° C
(wool program), without steam.
Using gentle
pressure with your iron, press down evenly on all parts decorated; after a few passages,
remove the silicone sheet, and check if it is possible to see the outline of
the decoration on the foil, continue until the outline will not be more or less
visible (always with the silicone sheet).
Wait until the
sheet is completely cold and then proceed to the removal of the transfer foil.
NOTE: this
operation, compared with the laminator transfer, may require a minimum amount
of manual ability and more attempts.
For any other questions
or concerns please contact us using the online form, we will try to answer as
quickly and comprehensively as possible.