Product Description:

 
This set is one of the most convenient type of adding nice touch to the empty embossed letters your car came with from factory. Do not hassle yourself with vinyl letters, ours are not paper thin, they are made of 0.15-0.20 gauge ABS plastic bonded with 3M Foam tape, covered with protective linings on both sides. 
 
Made in New-York by using laser technology so they are precisely cut for superior fitting. Material is always flexible, doesn't consolidate, so will never crack or rip and of course never rust. Installation takes only minutes and can be done without technical skills.
 Letters Schematic

 

Please contact us if you need any other color we stock: Piano Black, Chrome, Red, Yellow, Blue and Di-Noc Carbon Fiber at all time. 
 
 

Installation Instructions:

 
 
  • Step 1:  Thoroughly clean the area where the pieces are to be applied with an rubbing alcohol to remove ALL residue and dirt. Let it dry.

  • Step 2:  Without removing the red backing protective tape "dry-fit" ALL pieces, noting correct placement, joins and angles. Very Important Note:   ALL pieces should be checked "dry-fit" before proceeding to Step 3. Immediately stop installation procedure and contact us even if one piece doesn't fit.

  • Step 3:  Remove red tape from the back and apply pieces. It is not recommended to install letters when it's cold, let pieces be at least room temperature. 
 
ATTENTION! SURFACE OF EACH LETTER IS COVERED WITH WHITE PAPER PROTECTIVE TAPE. IT SHOULD BE GENTLY REMOVED AFTER INSTALLATION. RED SIDE IS THE ADHESIVE SIDE (IT IS SOFT TO TOUCH SO YOU DON'T MAKE A MISTAKE).