This is a brand new electric gear
motor that has an extremely high torque and is equipped with a wireless
latch controller.
The gear motor is measured to be 7 inch long and
the motor itself has a diameter of 2.5 inches. Drive shaft
is 10mm in
diameter with 2 flats where flat to flat is 6mm. The shaft has a threaded end
that is to fit a M6
tightening nut. Rated voltage of this gear motor is
13.5 VDC and maximum speed is 50 RPM. Rated
output load is 60 watts and
output toruqe at 50 RPM is 11.5 N-m (8.5 ft-lb). Mounting is based on M6
screw mounting.
The wireless controller functions as a reversible latch control switch from a 12v dc
power source. By
pressing the right side button once, the motor runs in one
direction continuously, by pressing the right
side button once again, the
motor stops; by pressing the left side button once, the motor runs in the
opposite direction continuously, by pressing the left side button once
again, the motor stops. Current rating
is 3 amps. Two transmitters (with
batteries) are included in this package. Wireless signal range is 100
ft.
This is a single speed system.
Manufacturer: Makermotor