2AB21MC1F2B2 - Goulds Pumps Aqua Boost II Booster System
1.5 HP - 208/230 Volt - 27 GPM Max - Single Phase - Cast Iron/Stainless Pump
FEATURES
The AquaBoost II variable speed
pump controller and complete booster package kits, provide an economical
answer for municipal water district customers with low water pressure.
Both domestic and light commercial applications can benefit. As water
use increases, the AquaBoost II changes pump speed to maintain pressure.
Large supply tanks are eliminated and less wear and tear on your pump
and motor.
Think of it as Cruise Control for your pump!
The AquaBoost II is available with a range of flow rates to handle
homes with up to four baths, irrigation, filtration and fire suppression
systems. Light commercial applications up to 100 GPM at 45 PSI boost.
The AquaBoost II is available as either a separate controller or as part
of a complete pump package with everything you need to plumb it to a
domestic water line.
Package Includes:
- 2 HP controller
- Wall mount set
- 208-230 V input
- MCC cast iron / stainless steel pump
- Transducer
- V6P (2 gallon) tank and pressure gauge
- Controller is pre-wired. Flows to 27 GPM.
AQUABOOST CONTROLLER FEATURES- Input Power* - 208-230V ±15%, single phase (controller only)
- Output Power - Up to 230V three phase (based on input voltage). Motor rated for 208-230V, ±10%.
- Maximum Output Current - 4.2 amps - 1AB2 (1 HP) - 6.9 amps - 2AB2 (2 HP)
- Input Controls - Up and down buttons to set pressure.
- Signal Lights - Power on, pump running, inverter stopped, pump stopped, standby, faults/errors.
- Electrical Efficiency - Over 95% at full load.
- Protection
Against - Short circuit, under voltage, overload, motor temperature,
dead heading, run out, suction loss, sensor fault, bound pump, over
voltage, static discharge.
Note: Suction loss/run out is set for minimum 10 psi at discharge - Ambient Temperature - 34_ F to 104_ F
- Maximum Humidity - 95% at 104_ F, non-condensing
- Air Pollution - Avoid mounting in areas with excessive dust, acids, corrosives and salts.
- Approvals - Controller Enclosure - Outdoor, NEMA 3R, IP 43 (Rain-tight)
- Mounting - Wall mount with mounting hardware.
- Cooling - Convection with cast aluminum heat sink. - 3 HP, 5 HP with temp. fan.
- Transducer - 0.5 - 4.5 VDC with 5 VDC power supply, 100 psi range, 80-inch 3-wire shielded cable.
- Input Wire - 5 feet of 14, 10 or 8 gauge cable. Depending on size, cable is pre-wired to controller and motor conduit box.
- Output Wire - 10 feet of 14 gauge cable. Cable is pre-wired to controller and pump motor (when provided).
*Low input voltage may affect motor operation.
PRESSURE RANGE
Nominal Range - Field adjustable from 20 - 80 psi, total system pressure.