An excellent machine for fine planeing work with a
particularly smooth finish for hardwood and softwood work pieces.
Perfect size unit for all kinds of applications, where precision to a
fraction of an inch is needed.
The unit's load bearing components are all made of die-cast aluminum,
with milled seats for bearings and spindles, being essential for
vibration-free, smooth and clean planeing, guaranteeing maximum
stability. The triple spindled table is milled to close tolerances and
can be conveniently adjusted to 0.1mm (0.008") by a large zero
adjustable hand wheel on top of the housing.
The cutter shaft has two HSS reversible cutters for a particularly long
service life. Replacement of the cutters is facilitated by means of a
generously sized service flap.
The planer has an automatic feed unit. The work piece therefore is only
pushed by hand into the feed slot for a short distance. A knurled and
spring-loaded roller then draws the work piece in, thus enabling even
irregularly shaped pieces of wood to be planed. After passing the cutter
shaft the piece of wood is pushed out at the rear by a rubbercoated
roller to protect the surface of the work piece.
The unit has a dust-protected on/off switch with restart protection in case of power supply interruption.
Technical data:
Volts |
110 - 120V AC, 50/60Hz |
Max. Power |
0.2hp (150W) |
|
no = 6,000rpm |
Feed speed |
14.4ft per second (4.8m/min) |
Max. pass-through height |
1 37/64" (40mm) |
Max. pass-through width |
3 9/64" (80mm) |
Length of planing table |
9 1/8" (232mm) |
Planing cutter length |
3 7/32" (82mm) |
Chip decrease |
1/32" (up to 0.8mm) |
Overall size |
11 x 9 x 9 1/8" (280 x 230 x 235mm) |
Weight |
17.6lb (approx. 8.0kg) |