Helps to protect your door sills from being scuffed/marked when entering/exiting your car with a stylish look.
100% Brand new, never been fitted or used.
Installation:
Very easy installation, please see the example (picture 5) of the fitting guide, these come with 3M tape already pre-installed on the back, peel and stick.
Firstly wipe your door sills and sill protector plates clean of any dirt/chemicals, we recommend using 50% alcohol as this will remove grease, polish etc..that may remain.
Test fit the sill protects position, to make sure you are happy.
Then proceed to heat the surface of the car body where the sill plates will be attached to, and also heat the back of the sill plates to a fairly hot temperature using a heat gun, if you don't have a heat gun then you can use a hair dryer.
This will help the sill plates attach to the car body, especially in winter when temperatures are low, bonding performance of the 3M glue attached to the rear of the plates can be deteriorated at a low temperature if not warm enough.
Simply peel the tape, then hold in place until properly secure, please ensure you position the sills correctly the first time because if you attempt to remove the sills again this could deteriorate the bonding performance of the 3M tape.
Do not wash around the door plates for at least 48 hours after installation.
NOTE: If you think the sills protectors need additional tape, then please attach this to the rear of the plates before installing, although this is optional and not always necessary.