Overview

    The perfect extension cab for DT25 amplifiers
    Front-ported, closed-back design
    12-inch custom Celestion G12H-90 speaker

Features

DT25 GIVES YOU FLEXIBLE CONFIGURATION
Plenty of connections for your playing setup.

Combine multiple DT25 amps to create incredible stereo rigs, wet/dry setups, and more. You can also use a standard MIDI switching system to control channel, voicing, reverb on/off, pentode/triode mode, and class A/AB selection. If you need channel switching and global reverb switching, connect any standard two-button footswitch with a TRS cable, or use a single-button footswitch connected with a TS (mono) cable for channel switching only. Or maybe you’ll want to leverage the Send and Return jacks to create a serial effects loop that taps the signal chain post-preamp. DT-amps will also let you connect an XLR cable direct out to a PA, mixer, or recording interface to recreate every detail of your tone, complete with full cab simulation. Or, connect a single 4-ohm, 8-ohm, or 16-ohm cab—or two 4-ohm or two 8-ohm cabs at a time. No matter what your needs may be, DT25 gives you a wide range of options for configuring your rig.


With traditional tube amps, your tone is set in stone. DT25 is different. Featuring a truly innovative design, DT25 allows you to reconfigure various analog components and build the custom tube amp of your dreams. Chose from 30 HD preamps—then tweak the negative feedback loop, operating class, power tube mode, and more in the reconfigurable tube power amp. You get an incredibly wide sonic palette, so you can finally dial up the tones in your head.

When you connect DT25 and POD HD using L6 LINK, the amp instantly has access to POD HD’s full collection of HD amp models and M-class effects. Set the POD HD to an HD preamp-only model to tap into the fully analog tube output stage of the DT25, and you’ll experience unparalleled dynamics and touch sensitivity. Plus, the massive collection of M-class effects that come with POD HD are grafted seamlessly onto the DT25—giving you massive array of tonal options. For example, your POD HD effects can be laid out with a virtual effects loop—you can place your compressor, distortion and modulation in front of the preamp model, with the delay and reverb feeding into the DT25 power section.

Connect your Line 6 gear.

The innovative L6 LINK jacks enable you to combine DT25 with your other Line 6 gear and unlock new levels of sonic potential. All it takes to make an L6 LINK connection is a single XLR cable. L6 LINK connections are free of the noise and hum issues you can run into when trying to achieve similar functionality with the four-cable method and other multi-cable configurations.


DT25 GIVES YOU FLEXIBLE CONFIGURATION
Plenty of connections for your playing setup.

Combine multiple DT25 amps to create incredible stereo rigs, wet/dry setups, and more. You can also use a standard MIDI switching system to control channel, voicing, reverb on/off, pentode/triode mode, and class A/AB selection. If you need channel switching and global reverb switching, connect any standard two-button footswitch with a TRS cable, or use a single-button footswitch connected with a TS (mono) cable for channel switching only. Or maybe you’ll want to leverage the Send and Return jacks to create a serial effects loop that taps the signal chain post-preamp. DT-amps will also let you connect an XLR cable direct out to a PA, mixer, or recording interface to recreate every detail of your tone, complete with full cab simulation. Or, connect a single 4-ohm, 8-ohm, or 16-ohm cab—or two 4-ohm or two 8-ohm cabs at a time. No matter what your needs may be, DT25 gives you a wide range of options for configuring your rig.

Thank you for shopping with Sweetheart Deals!