This item is a new overstock that was found sitting in inventory.  It has been discontinued by Hyperion, and replaced with the EOS 0720i NET3.

______________________________________________________

The EOS 0720iNET is a carefully-designed charger with many built-in safety features, such as reverse polarity protection, input voltage error warning, and cell-count mismatch warnings for lithium chemistry batteries.

Specifications & Features: 

• 250W max CHARGE Output 

• 0.1A to 20.0A max Charge Current in 0.1A steps (constrained by 250W max) 

• 80W/10A max DISCHARGE limits 

• STORE MODE allows fast and simple discharge to ~60% capacity for proper storage of Lithium Battery types = longer battery life. 

• Charges/Discharges 1 to 7 cells Lithium Polymer Batteries Per Port (3.7V/cell nominal types) 

• Charges/Discharges 1 to 7 cells Lithium Ion Batteries Per Port (3.6V/cell nominal types) 

• Charges/Discharges 1 to 7 LiFePO4 (A123) cells (LiFePO4 3.3V/cell nominal, A123 3.3v support) 

• Charges/Discharges/Cycles 1-16 cell NiCd/Ni-MH in three modes: Normal, Linear, and Automatic 

• Charges/Discharges 1~12 cell Lead Acid Batteries (Pb, 2V/cell) 

• Allows Lithium-Type batteries to 50,000mAh and PB (lead/acid) batteries to 100Ah capacity 

• Built-in Hyperion LBA10 Balancer with 300mA max balance rate/cell 

• TCS - Terminal Capacity Selection 

• Rich Data Displays during and after charging and balancing 

• PC Port for Data Logging and Firmware upgrades 

• Temperature Sensor Ports & Temp Stop settings* 

• Wide Voltage Input Range 11v~28v for higher efficiency when charging high-voltage packs, and compatibility with a wider selection of AC/DC power supplies 

• Power Supply Amperage Control to allow reliable charging with lower-output power supplies 

• Power Supply Voltage Control (PS Load Control) works in concert with Amperage control to insure the charger does not overload your power supply 

• Input Cable with 4mm Male Connectors + Clamps 

• Output Cable Set Included, with 4mm Connectors 

• Integral, Thermostat-Controlled Cooling Fans 

• Rugged Aluminum Case with Insulating End Caps 

• 2-Line, 16-Character, Yellow Backlit LCD Data Display. Highly visible in all conditions 

• 10 User-definable Memory Positions 

• Firmware upgradable via Win PC 

** EOS0720iNET is designed to charge single Lithium-based packs up to 7S max. For “flight packs” higher than 7S, Network two 0720i in SYNC MODE for charging of two packs to make a single series-wired flight pack. (series-wired flight packs from 2x2S=4S to 2x7S=14S are possible) 

* Temp sensors available separate: #HP-EOSTMPSEN or EOS1210i-SEN 

** Firmware upgrades require USB Adapter #HP-TI-PRGUSB and harness #HP-EOS06- PCCBL. Firmware upgrades will only become available if and when improvements are identified in future. 

The manual for this charger can be downloaded from Hyperion's website. Software updates and pc link software is also available from Hyperion's website.