Important Information About Using Your VueSonic Advance Device:
VueSonic Advance is suitable for cleaning gas permeable (RGP) lenses.
For seriously contaminated lenses, treat the lenses in Menicon Progent A and B for 20-30 minutes, or soak in RGP solution for 2-4 hours before cleaning with VueSonic Advance. If Menicon Progent A and B is used, rinse the lenses thoroughly before putting them into VueSonic. It is ok to run VueSonic Advance multiple times for deep cleaning.
Do not remove the silicone damping heads from the transparent lid.
If the green light is off during use, this indicates that the battery needs to be changed.
Wash hands before each use.
Water may damage the electrical part of the device. Avoid solution or water going under the lens holder.
Changing the silicon lens holder, cushion, and damping heads every 3 months is highly recommended.
VueSonic Device Features:
Plastic device body
Battery holder
Sliding cover
Transparent plastic lid with attached silicone damping heads
Removable silicone lens holder and lens cushions
Start and Stop button
Indication lights
Instructions:
Insert two AAA battery into the battery holder and close the battery cover.
Slide to open the device cover and examine the damping heads and lens cushions to ensure that no dust or debris has collected on them.
Gently place a contact lens in both the left and right silicone lens cushions, with the concave sides facing up.
Add a few drops of contact lens solution into the removable silicone lens cushion, letting the solution cover the lenses without overflowing.
Cover the removable silicone lens holder by the transparent plastic lid with attached silicone damping heads, and slide back the cover.
Press the START/STOP button on the side of the device. When VueSonic Advance is operating, a red light will be on, a green light will flash (indicating a full battery), and the device will vibrate. Each cleaning session lasts 2 minutes. If necessary, repeat the session for deep cleaning.
You can store lenses in the VueSonic device after cleaning. Remember to change the solution before the next use.
Once a week, soak the transparent plastic lid, silicone damping heads, lens cushions, and removable silicone lens holder in boiling water for 3 to 5 minutes. Use high-quality tissue or air dry before putting them back into the device.
Change the silicon replacement kit every 3 months. It is sold separately on eBay.