Notes: We're the manufacture, welcome to be our wholesalers, please contact !

Note: Pixpilot is a PPM-input autopilot, which means that it gets RC input from a single cable to the receiver, either via the PPM port, the Futaba S.BUS port, or the special satellite receiver port for Spektrum gear. Most RC receivers allow for PPM output, but some, such as non-S.BUS Futaba receivers, do not. If your receiver does not support PPM output, please order a PPM encoder board  http://www.ebay.com/itm/281612568703

◆Pixpilot basic kit includes

·Pixpilot autopilot x1

·MicroSD 4G x1 (in the pix)

·MicroSD Card Reader x1

·30mm Buzzer x1

·E-Switch Safety switch button x1

·I2C Splitter expand module x1

◆Features

Advanced 32 bit ARM Cortex® M4 Processor running NuttX RTOS

14 PWM/servo outputs (8 with failsafe and manual override, 6 auxiliary, high-power compatible)

Abundant connectivity options for additional peripherals (UART, I2C, CAN)

Integrated backup system for in-flight recovery and manual override with dedicated processor and stand-alone power supply

Backup system integrates mixing, providing consistent autopilot and manual override mixing modes

Redundant power supply inputs and automatic failover

External safety button for easy motor activation

Multicolor LED indicator

High-power, multi-tone piezo audio indicator

microSD card for long-time high-rate logging

◆Specifications

Microprocessor:

32-bit STM32F427VIT6 Cortex M4 core with FPU 168 MHz/256 KB RAM/2 MB Flash

32 bit STM32F103C8T6 failsafe co-processor

Sensors:

ST Micro L3GD20 3-axis 16-bit gyroscope

ST Micro LSM303D 3-axis 14-bit accelerometer / magnetometer

Invensense MPU6000 3-axis accelerometer/gyroscope

MEAS MS5611-01BA03 barometer

Interfaces:

5x UART (serial ports), one high-power capable, 2x with HW flow control

2x CAN

Spektrum DSM / DSM2 / DSM-X® Satellite compatible input up to DX8 (DX9 and above not supported)

Futaba S.BUS® compatible input and output

PPM sum signal

RSSI (PWM or voltage) input

I2C®

SPI

3.3 and 6.6V ADC inputs

External microUSB port

Power System:

Ideal diode controller with automatic failover

Servo rail high-power (7 V) and high-current ready

All peripheral outputs over-current protected, all inputs ESD protected