I'm much more into FPV then 3D plus I'll never be able to use it to it's potential, so here's what I have:
Hyper 400 assembled frame with motors and flight controller.
- Lemon DSMX sat
- 2 sets of zeal props (1 set NIP)
- 1 NIP set of neo props (3 used props of another set)
- NIP set of prop spacers 
- NIP set of leap props (Black)
- 1 complete set of HQ 8x4.5 normal props for sport flying 
- All original packaging, manuals, accessories
- 1 glacier 2200 mah 4s pack, slight puff, but works like a champ
- 1 New in box Pulse 4s 2250 45c
- Eflite EC3 connectors installed on glacier battery and on quad
- Scorpion battery strap

I bought this after my first hyper had an esc failure right out of the box and was waiting on parts, this also had an esc issue on flight 5 and that was replaced, along with two motors and all the booms and has had 19 flights since with no issues at all. The " fender" portion at the front of the canopy has been trimmed back due to prop strike issues, and Velcro added to the frame and canopy, but the included spacers will make that problem disappear. There may be light scrapes present as well, but nothing that could photograph 

Upon arrival at your place, the quad will need the following:
- binding to your radio (or receiver installation if you don't use spektrum)
- full naze32 setup
- esc calibration to your radio
- motor spin direction check.
- If using anything other then the zeal props, the shaft hole will need to be opened up to 6mm and the correct prop adapter size chosen (HQ props)

This machine was tested right before the auction was posted and it worked flawlessly. If it had a camera on it, I'd keep it. Super responsive and powerful.

No returns will be accepted once you begin setup and any issues due to poor setup or wrong setup will not be covered, just due to the nature of the hobby.