Solar Controller Diversion load regulator Charge regulator Charge controller Battery regulator 12 volt 24 volt 48 VDC volt wind power charge controller renewable energy dump load diversion load
YOU ARE BIDDING ON ONE NEW
10,000 Watt WIND / SOLAR
CONTROLLER  for 12 volt battery
inputs for all solar and wind turbine charging sources.

WIND/SOLAR 12 VOLT /  DUMP / DISCONNECT CHARGE CONTROLLER 

WITH BUILT IN DIGITAL DISPLAY AND INTELLIGENT

This is a huge hybrid wind and solar charge controller.
Use for wind or solar or both Also use for hydroelectric and solar combinations both. User changeable settings -- Several controllers on the market only let you set the dump level!

    Can divert the charging source from the batteries to the load, or dump both the batteries along with the charging source.
    You can connect both wind and solar at the same time
    Reverse polarity protection
    Ultra low power consumption even with the volt meter on (almost negligible). You can even set the volt meter to turn off after in-activity.
    On board relay- Isolates electronics from back voltage spikes.
    This is important to get the longest life out of the electronics. No body else has this!
    Dual (2) Microprocessor controlled -- Extremely  stable and very accurate
    Multiple user changeable settings, and trip points for many various system requirements and applications- You can change the dump point voltage level,
    end of dump voltage level, length of time in divert mode when end dump point voltage is reached (between 0 to 999 seconds, or 0 to 999 minutes) 
    Isolated Electronics Protection - Impossible to accidentally connect wind or solar directly to the circuit board.

For solar panels and solar input to battery

IT CAN DISCONNECT THE INCOMING POWER 

OR DIVERT IT TO A DUMP LOAD. 

Battery regulator for both your wind and solar battery input power. This
regulator can either dump extra power creating free hot water or heat or
just cut off extra power to keep your batteries from over charging. This
unit is a must for wind turbine applications as it uses a mechanical
relay which can handle high voltage surges unlike solid state controllers.


15 years of great products

This controller can also CUT-OFF incoming power so NO DUMP LOAD resistor is needed if you do not want

  This item is the only controller that will work with wind turbines Do not buy solid state controllers as they will burn out in high wind conditions.  This controller was specially developed for wind turbines. Also works on solar too - Get one battery controller to do it all!


Wind & Solar Controller

 
This controller can divert or simply disconnect
incoming power without an electrical arc occurring -

HOW POWER DRAW DYNAMICS WORKS:

If you use it as a DIVERSION or DUMP load MODE then it uses almost no power when it is NOT dumping (energy efficient sensing)

  Used to prevent battery over
charging on Wind - Solar - Hydro
 
A battery regulator diverts excess power to power
some other useful device when ever your battery is full.
 
Use the this excess power to make free hot water or to recharge an auxiliary battery bank, so many uses!

Has push button load tester.

 
An extremely robust unit!
draws almost ZERO power while sensing! 99.998% electrically efficient while sensing!
 

HOW POWER DRAW DYNAMICS WORKS:
If you use it as a DIVERSION or DUMP load MODE then it uses no power when it is NOT dumping (energy efficient sensing) In DISCONNECT mode it draws 0.2 amps but that's good since that means you have to much power in your batteries anyhow.

The modern way to monitor your battery from over charging is to have a diversion load that performs another task such as heating water when your battery is in danger of over charging. Shutting down the output of your wind turbine or your other renewable energy devices is old school thinking. Now-a-days most people dump their excess power into some other legitimate device optimizing their energy independence. Hot water from your excess power can be used for radiant heating in the winter or even in the hot summer months for washing cloths or dishes and for bathing. You will always find a need for hot water in your life.


Extra heavy duty continuous duty relay that can handle millions
of cycles at very high amp loads without fusing together or sticking! -

"Electro mechanical units ours are impervious to lighting, EMP and static electrical discharges"

"Simple and ultra-reliable" - "A BULLET PROOF SYSTEM"


    CUT MODE OPERATION