UniqueMotoLights only picks the best quality and the best performing projectors, best quality ballasts and wiring/relay harnesses. we do not sell cheap generic projector kits, and we always display pictures of the kits being sold.

Please take a moment to look at all the other Ebay sellers, selling low end generic projector kits, none of them even show the exact product being sold, only a generic picture.

These are the best projectors that will directly fit your motorcycle headlight, without any modifications or cutting up your headlight!. They are very bright and much brighter than any stock headlight; A great light cut off; they are not like the cheap hid's that will blind everyone around you.

This kit is tested by us to fit perfectly into the above listed headlights with no modifications what so ever!, no cutting up the headlight required.

Simply Open up your headlight, insert the projectors though the light bulb holes, then secure them on the back of the headlight with the provided nuts. IT'S THAT EASY!
 
Each kit will include everything that you need to install:
 
* 2 Bixenon projectors (high beam and low beam)
* 2 35w H1 hid bulbs (4300K - Crystal White beam OR 6000K - white beam with a slight blue hue, OR 8000K for a blue light beam)
* White halo angel eyes (Other colors could be special ordered)
* 2 Digital slim ballasts
* 2 Low profile Motorcycle wire harnesses to power the projectors
* 2 Halo inverters
 
 
This kit is practically plug and play, no modification or cutting of headlight required!.
 
you will even retain the original headlight height adjustment feature to adjust the heaight of the light beam.
 
 
Options:
* Angel eyes color BLUE,RED,GREEN , is also available (Additional $20)

General installation instructions:

1. Remove headlight from bike
2. bake headlight in the oven for 5-8 minutes at 200 degrees, once the glue softens up, use flat head screw drivers to remove lens from headlight; you might need to repeat this a few times untill the lens is off.
3. Insert projectors into the light sockets, using the supplied adapter plates, fish halo wires though small hole at the base of the socket ( you might need to cut the halo wires, then reconnect once assembled).
4. put headlight back in oven for 5 minutes at 200 degrees to get the glue soft again, then close up the headlight.
5. connect wiring harnesses to battery and high and low beam signals, connect halo inverters to ground and low beam signal.
6. find a good spot for the ballasts and wiring harnesses
7. put the bike back toghether
8. enjoy!

Ninja 250R 

Ninja 650R
 

 

Blue CCFL Halos:

 

White CCFL Halo's:

Micro H1 Projectors

 

 

 

Slim Low profile Motorcycle wire harness, (you will receive two harnesses, one for each projector).

 

Slim Ballasts, (you will receive two ballasts, one for each projector).