20 St Aluminum Brazing alloys 1,6x500 mm + 100g Flux paste Hard soldering
Delivery Offer
- 20 bars A 407 L dim. 1,6 x 500 mm
- 100 g F 400 MD
- Flux brush
- Technical data sheets for the products
- Safety garden datasheets in PDF format by email
- Information Brochure "Aluminium Brazing" as a PDF file via email
Attribute A 407 L
The Aluminiumhartlot A 407 L is a thin flowing AlSi brazing alloy, which is used for the new production of small aluminum components. The capillary-Al- Si alloy is used for structural and tonal joints of aluminum and rolled or cast aluminum alloys such as
Al 99,9 , Al 99,5 , Al Mn, Al Mg Si 0,5 , Al Mg Si 1, Al Mg Mn, Al Mg 1, Al Mg 2; Al Si cast alloys used. The solidus of the base materials should> 630 amounted ° C.
A 407 L is suitable for aluminum and aluminum alloys with a magnesium content of up to 3,00 %. Not suitable for joints that are subsequently anodised.
Norms
DIN EN 104 4: AL 104
DIN 8513 : L - Al Si 12
Technical Features
Melting range: 575 - 585 ° C
Working temperature: 590 ° C
Tensile strength: 100 N / mm
Specific weight:. 2,70 g / cm³
Due to its flow properties and its high operating temperature of this solder is not suitable for repairing cracked or broken components. For this work, low-melting aluminum solders or aluminum Reiblote should be used. Offers for these solders can also be found here in the shop.
Product Features F 400 MD
Norms
DIN EN 104 5: FL 10
DIN 8511 : F-LH 1
The flux F 400 MD is a corrosive, highly active flux in paste form. It has proven itself in many applications in the field of brazing aluminum. The magnesium content in the base material should be 2,00 not exceed%.
Due to the high flux proportion F 400 MD economical, it is odorless and midstream radicals are highly soluble in water. Flux residues must be thoroughly removed after the soldering of the components.
If you are not sure that this product is suitable for your soldering application, call us before buying call or send us an email with your questions. We will advise you and assist in the selection of the appropriate solder.
We carry more aluminum alloys in the program. These can also be found here in the shop.
All information about our products, equipment and processes is based extensive research work and application technology experience. We communicate these results orally and in writing in all conscience, the however exempting the consumer from the obligation, our products and to examine methods responsible, especially if the application and The method we are not a USD were approved rücklich writing.