DESIGNED FOR THE
KAWASAKI
BRUTE FORCE 650 / 750
ENGINE BRAKE (KEBC) ACTUATOR BYPASS
WORKS ON MODELS UP TO 2011
Why a Bypass is Needed
When the KEBC actuator is disconnected or broken the signal between the Controller, 2WD/4WD Switch, and Indicator is disrupted causing the dash indicator to flash back and forth. This Bypass Relay replicates the original signal sent by the KEBC, once installed the KEBC can be completely removed.
How it Works
The Bypass Relay replicates the signal the Brake Acutator would have sent if it were connected / functioning.
- When the 2WD/4WD switch sends a signal to the controller the Bypass Relay does not send a signal to the dash indicator light.
- When the 2WD/4WD switch does not send a signal to the controller the Bypass Relay does send a signal to the dash indicator light.
What's Included
- (1) Bypass Harness
- (1) 12v SPDT 30/40A Relay
- (1) 20A Fuse
- (3) 14-16awg Scotchlok T-Taps
- (5) Zip Ties
- (1) Set of Detailed Instructions
Please Verify
The engine brake actuator may not be responsible for the flashing dash indicator. Please verify the failure part before you purchase this kit.
Simple 10 Step Install
No Soldering of Wires
Easy Crimp and Connect Quick Disconnects
Inline Fuse Holder
Made With Quality Parts
Bypass Harness
Detailed Installation Instructions
***By acquiring this product you the purchaser acknowledge that you are aware that manipulation of the original vehicles wiring is required. The purchaser also acknowledges that damage to the vehicle may occur if the instructions are not properly followed. Any damage that may occur is solely the responsibility of the installer. By purchasing and/or attempting to install this bypass you are agreeing to assume all liability in its installation. If there is something that does not seem right during your installation ask before you act.***
