FULLY ASSEMBLED AND PROGRAMMED READY TO GO!
SEE VIDEO ON HOW TO USE IT. CLICK HERE!
CUT MODE
Battery regulator for both your wind and solar battery input power.
This
regulator can either dump extra power creating free hot water or heat
or
just cut off extra power to keep your batteries from over charging.
This
unit is a must for wind turbine applications as it uses a
mechanical
relay which can handle high voltage surges unlike solid
state controllers.=
VIDEO OF 15 years of great products
For solar panels and solar
LOWEST COST 440 AMP CHARGE OR DIVERT CONTROLLER WITH DIGITAL DISPLAY ON THE MARKET
Max solar amperage in divert (dump) mode is 440 amps. This is a big hybrid wind and solar charge controller.Use for wind or solar or both at the same time! Also use for hydroelectric or solar or both.
User changeable settings -- Several controllers on the market only let you set the dump level!
Connect multiple turbines and solar panels up to 440 amps worth at the same time!
Max continuous solar amperage in disconnect mode is 100 amps. 440 Amp in Dump.
Can divert the charging source from the batteries to the load, or dump both the batteries along with the charging source.
You can connect both wind and solar at the same time. Reverse polarity protection
Ultra low power consumption even with the volt meter on (almost
negligible). You can even set the volt meter to turn off after
in-activity.
On board relay- Isolates electronics from back voltage spikes from large 440 amp relay.
This is important to get the longest life out of the electronics. No body else has this!
Dual (2) Microprocessor controlled -- Extremely stable and very accurate
Multiple user changeable settings, and trip points for many various system requirements and applications- You can change the dump point voltage level,
end of dump voltage level, length of time in divert mode when end dump point voltage is reached
Isolated Electronics Protection - Impossible to accidentally connect wind or solar directly to the circuit board.
High amp rating - 440 amps, 10,000 watts surge peak max.
Battery Status digital - Lets you know your battery's actual voltage in real time!
Plug and Play - Long leads for easy termination to your 12 volt battery or battery bank.
Battery regulator for both your wind and solar battery input power.
This
regulator can either dump extra power creating free hot water or heat
or
just cut off extra power to keep your batteries from over charging.
This
unit is a must for wind turbine applications as it uses a
mechanical
relay which can handle high voltage surges unlike solid
state controllers.
HOW POWER DRAW DYNAMICS WORKS:
Has push button load tester.
HOW
POWER DRAW DYNAMICS WORKS:
If you use it as a DIVERSION or DUMP load MODE then it uses no
power when it is NOT dumping (energy efficient sensing)