This is for 1 62 Plate HHO Dry Cell for 120 AC current power source (Standard 120 Household power), ready to connect to your hardware and plumbing.
This Dry Cell is designed for normal household power sources and using the supplied bridge rectifier, converts the 120 AC to 120 DC to operate the cell with.
This Dry Cell is can to produce 3 to 7 LPM of HHO
depending on user variables of KOH mixture, setup, and amps/wattage of the setup.
***Free Shipping Within the United States***
This Fuel Cell is Shipped USPS With Tracking Number
This Item Ships Direct Within 24-48 Hrs of Purchase.
| Some uses for an HHO Dry Cell configured for 120V AC. |
|
- Torch |
| Contents |
|
The cell comes
complete and assembled. 1. 62 Plate HHO Dry Cell Configured for 120v 2. 1 200v / 50 amp bridge rectifier with 12" of 10awg wire with electrical connectors ready for installation 3. 2 3/8 barbed
Y fittings for your hose.. |
| Dimensions & Specs | |
| Model # | ACAU-62 |
| Manufacturer | Fuel Cell LLC |
| Length: | 11" / 12.5" Including fittings |
| Height: | 6" / 7" W/Terminals |
| Width: | 3.5" |
| Surface Area: | 1550" Sq |
| Hose Fittings: | 3/8" NPT - 3/8" Barbed for 1/2" Hose (Can be swapped out in seconds for your own needs) |
| Optimal Performance: | 120 Volt, |
| MMW: | 6 to 7 MMW avg |
| Arrangement | 120 volt total, 2 volts across each plate. at Negative connection, 2 plates on either side tabbed so the user can adjust the if they want to. |
| End Plates | High Tensile/High Heat CPVC 1/2" - Many times the strength of cheap acrylic and chemically resistant |
| Ship Weight | 11 LBS |
| Efficiency | Less current loss while better
utilizing current balance through the cell due to configuration. This allows for more production
for each amperage consumed by the dry cell. Average efficiency is apx 20%-25% more then run of the mill cells. |
******This section pertains to
standard 12-14 volts DC... At 120 VOLT, start out with a 5% KOH mixture
and add more as you see fit for your own comfort and safety level.******
| Use only "Potassium Hydroxide (KOH)" with
"Distilled Water". Yes, I've actually
had someone use the wrong chemical in an HHO Dry Cell and the result was that
customer was not producing HHO at all, just steam and toxic gases. So I thought
I would clarify this. the customer never asked a question, so I never heard a
word until after the fast. Can't help someone if the question is not asked. How Much Potassium Hydroxide to use: A great mixture volume is 20% KOH (Potassium Hydroxide). This mixture will have the best amperage draw, and thus produce the most amount of HHO for volt/amperage. For very harsh cold environments, it is perfectly safe to increase the volume of KOH to 28%. To determine the right mixture, 20% KOH by weight = 27 ounces of KOH per 1 Gallon of Distilled Water. Do not use baking soda, sodium hydroxide, tap water, salt water, lye, or other chemicals. Only potassium hydroxide. Some of these have inefficient production values and some are very caustic (corrosive). A great tip for HHO dry cells, add a little bit of Anti Foam, which can be found in any spa/jacuzzi/hot tub supply store. Do not mount HHO dry cells next to an exhaust on a vehicle. The exhaust can reach 600f easily and that is dangerous. Best mounting positions for an hho dry cell is low in a fender well, in front of the grill down low behind the bumper, etc. |
Cautions: Hydrogen is highly explosive. Use extra care during cell operation. Keep away from open flame. Do not touch or be near the hydrogen cell when in operation.
Disclaimer: You must be age 21 and over to handle hydrogen devices. When purchasing this device, you are held responsible for any damage that may accrue during installation or operation of this unit. Fuel Cell LLC is not held liable and holds no responsibility for any personal harm or property damage.
Shipping: This item will ship within 24hrs - 48hrs of payment verification. *Canada, Note: Shipping to Canada is precisely using UPS Ground, shipping cost is the exact amount between USPS postage within the United States and UPS Price to ship to Canada. Actual UPS Ground is $33, I am charging $25, so yes, you are getting a good deal :)